Put your key in the ignition and turn it to position one, which is the position right before starting the car. Push and hold the trip meter reset button on the dashboard, then turn the key to position two. Keep holding the odometer button for 10 seconds. The light should then flash, beep, and then go out.
Likewise, how do I reset my RAV4 screen? Place your key in the ignition lock and set it to the On position, or press the Engine button twice, but do not turn on the engine. Wait for the multimedia screen to power on. Press and hold the PWR-VOL knob for 12 seconds. Toyota Entune should reset and function as normal.
Also, how do I reset my RAV4 computer? Turn the Rav4 off and take the key out of the ignition. Reinsert key but shift to the “acc” or “on” position and then “off” again. Repeat this cycle 3 times witH3 second intervals in between each step. At the end of the third cycle, turn the engine on once again.
As many you asked, how do you reset the maintenance light on a Toyota RAV4?
In this regard, how do you reset the maintenance required light on a Toyota RAV4?
- Press the Left or Right Arrow on the Steering Wheel to Navigate Settings.
- Select the Gear Icon on the Multi-Information Display.
- Press the Up or Down Arrow and Select Vehicle Settings.
- Press the Up or Down Arrow and Select Scheduled Maintenance.
- Turn the Navigation system “On” and press the “Setup” button located on the right side of the unit.
- Select “General” from the top right side on the touchscreen menu.
- Press the “Down” button to select “Delete Personal Data.”
Contents
How do I calibrate my Rav4 touch screen?
How do I reset my car dashboard?
How do I manually reset my car computer?
How do I reset my car without disconnecting the battery?
- 3.1 Step 1: Open the hood and disconnect the battery.
- 3.2 Step 2: Locate the car’s fuse box and remove the fuse.
- 3.3 Step 3: Reinstall the fuse and reconnect the battery terminal.
- 3.4 Step 4: Start the vehicle and perform a test run.
How do I reset my Toyota warning light?
Put your key in the ignition and turn it to position one, the position just before starting the car. Push and hold the trip meter reset button on the dashboard, then turn your key to position two. Continue holding the odometer button for 10 seconds. The light should then flash, possibly beep, and then go out.