Press the right dashboard knob until You reach the settings menu. Turn the knob to the right and then turn it again to scroll and select the Maintenance menu. Select the Service menu and choose RESET.
In this regard, how do I turn off the maintenance required light on my Nissan Rogue?
- Turn the Ignition ON. Don’t start the Engine.
- Press the NAVIGATION BUTTONS to Display SETTINGS.
- Under MAINTENANCE select the maintenance you want to RESET.
- To reset simply SELECT RESET in the menu.
- Then Select YES to confirm.
- Turn the Ignition OFF.
Also, how do you reset the service engine soon light on a Nissan Rogue?
- Open the driver’s side door and get into the drivers seat.
- Insert the key into the ignition and turn it a quarter turn so the ignition turns on, but the engine doesn’t start.
- Step on the gas pedal and quickly release it.
- Wait 10 seconds.
As many you asked, how do you reset the maintenance light on a 2011 Nissan Rogue?
- Turn the ignition to run (one position before starting engine).
- Press the square button repeatedly until SETTINGS is highlighted.
- Press the square button to select SERVICE and follow the prompts to RESET.
You asked, how do you reset the maintenance light on a 2012 Nissan Rogue?
- Press and hold the reset button.
- Turn the ignition back to the ON position while holding the reset button.
- Watch the oil change or maintenance light carefully.
- Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.
Contents
How do you reset the service engine light on a Nissan?
- Turn off your car’s ignition.
- Put on safety goggles and gloves.
- Locate the negative terminal of your car’s battery.
- Loosen the nut on the negative battery terminal with a wrench, then pull the connector off the battery.
- Reconnect the negative cable and re-tighten it.
How do you reset service engine soon light?
- Turn the ignition switch to the on position but do not start the car.
- Count seven seconds, depress the gas pedal and hold it down for 10 seconds or until the service engine soon light begins flashing.
How do you reset the service engine soon light on a 2009 Nissan Cube?
- Sit in the driver’s seat.
- Turn the ignition key to the ON position and wait three seconds.
- Fully depress and release the accelerator pedal five times in less than five seconds.
- Wait exactly seven seconds.
How do you reset the maintenance light on a 2013 Nissan Rogue?
How do you reset the service light on a 2013 Nissan Rogue?
How do you reset the oil light on a 2013 Nissan Rogue?
To reset the oil light on a 2013 nissan rogue put the car in the run position, go to settings, then go to service and hold down reset. The 2013 nissan rogue oil reset is done by putting the car in the run position, press settings until you get to service then hold down the button.
How do you reset the oil light on a 2017 Nissan Rogue?
How much oil does a 2013 Nissan Rogue take?
Capacity: 4.9 quarts. (with filter)After refill check oil level.
How do you turn off the change oil light?
Why won’t my change oil light go off?
If your oil light stays on even after changing your engine oil, you’re going to want to check the sensor first to rule out a malfunctioning sensor as the cause. … The oil pump may not be circulating enough oil to keep the engine’s parts lubricated and functioning properly, which can in turn cause multiple engine issues.