Contents
How much is a starter for a 2008 Malibu?
We currently carry 11 Starter products to choose from for your 2008 Chevrolet Malibu, and our inventory prices range from as little as $129.99 up to $372.62.
Where is the starter located on a 2009 Malibu?
1. Malibu.
2. Starter.
3. Bolt.
Where is the starter located on a 2010 Chevy Malibu?
The 2010 Chevy Malibu starter is found on the base of the engine. It is located on the rear side of the transmission housing. The starter is essentially an electric motor that spins the engine when You turn the ignition key, allowing the engine to turn on.
What are symptoms of a bad starter?
1. Something sounds off.
2. You’ve got lights but no action.
3. Your engine won’t crank.
4. Smoke is coming from your car.
5. Oil has soaked the starter.
6. Look under the hood.
7. Tap the starter.
8. Adjust the transmission.
How can you start a car with a bad starter?
1. Begin with Examining the Connections.
2. Examine the Engine Ground Connection.
3. Examine the Solenoid Cable of the Starter.
4. Check for Corrosion.
5. Softly Thump the Starter with a Hammer.
6. Jump Start the Car.
7. Push the Car to Start.
8. Examine the Flywheel of the Engine.
How much does a starter cost for a Chevy Malibu?
Chevrolet Malibu Starter Replacement Cost Estimate. The average cost for a Chevrolet Malibu starter replacement is between $459 and $480. Labor costs are estimated between $81 and $102 while parts are priced at $378.
How much does a starter cost for a 2009 Chevy Malibu?
We currently carry 18 Starter products to choose from for your 2009 Chevrolet Malibu, and our inventory prices range from as little as $93.99 up to $243.99.
How much is an alternator for a 2008 Chevy Malibu?
2008 Chevrolet Malibu Alternators from $101 | CarParts.com.
How do you test a starter?
How long does it take to replace a starter?
between 2 and 4 hours
How do you jumpstart a starter?
How do I replace my starter?
1. Safety First. Disconnect the battery.
2. Remove the Wiring. Remove the wiring and positive battery cable from the starter solenoid.
3. Remove the Starter and Bolts. Remove the starter retaining bolts.
4. Compare to Verify.
5. Transfer Heat Shield.
6. Replace with New Starter.
7. Secure and Tighten.
8. Connect the Wiring.
Where is the starter located?
Listen for a clicking sound coming from under the hood and look for a cylindrical part bolted near the engine. There are usually two hex bolts securing the starter, though there can be more. If you can find this part without too much hunting around, it is the starter.