Correspondingly, how do you reset the maintenance required light on a Toyota Prius? Turn the vehicle completely off. Press and hold the “Trip” or “MPH” button. Continue to hold the “Trip” or “MPH” button while switching the ignition to “On” without starting the engine. Release the button when the trip meter is set to all zeros.
Considering this, how do I reset my 2007 Prius?
- Disconnect battery cables, first negative, then positive.
- Cover and protect the battery posts!
- Turn ignition to position II.
- Connect both battery cables (“SHORT”) for at least 10 minutes.
- Wait 10 minutes – then ignition off, key out.
- Reconnect battery positive, then negative.
- OBC says “PPPP”, reset time.
Best answer for this question, how do you reset the maintenance light on a 2008 Toyota Prius?
Additionally, how do I turn off the maintenance required light?
Contents
How do I reset my Prius battery?
Try pulling over and turning the car off for a few minutes to reset it. If the hybrid check light comes on while you’re driving, pull over somewhere safe. Turn off your car and let it sit for 5-10 minutes. Then, try starting it back up again to reset it.
How do you reset the code on a Prius?
- Connect the scan tool to the onboard diagnostic connector. This is found under the steering column.
- Press the READ button on the scan tool, and look for any error codes.
- Press the ERASE button on the tool to remove the error code. The check engine light will then turn off.
How do you force start a Prius?
How do you reset the maintenance light on a 2009 Toyota Prius?
To reset your prius simply press the power button once to power your prius down. Press and hold down the odo button and press the power button twice (2x) with your foot off the brake.
How do you turn off the maintenance required light on a 2006 Toyota Prius?
How do you reset the maintenance light on a 2010 Toyota Prius?
Why is my maintenance required light still on after oil change?
Most often this just means your vehicle might be due for an oil change. The light will come on and remain on if the distance driven exceeds 5,000 miles after the maintenance data has been reset.
How do you turn off the maintenance required light on a Toyota push start?
Push and hold the dashboard odometer button and turn the key to position two. Keep holding the odometer button until the maintenance light starts to flash. You might even hear beeping noises. The light should go out.