Quick Answer, how do you change a serpentine belt on a Toyota Corolla?
You asked, how do you adjust the serpentine belt on a 2010 Toyota Corolla?
You asked, can I replace a drive belt myself? You can replace a serpentine belt with ordinary hand tools. But we don’t recommend it. The spaces are often tight and the belt-driven devices difficult to reach. … The belt placement tool allowed us to remove and properly place the new belt without reaching down into the pulley area.
Also, how expensive is it to replace a serpentine belt? A typical serpentine belt start at around $25 and goes up to $75 at most. If you know some car repair basics, you could change the belt yourself, and it may save you paying labor charges somewhere between $75 and $120. All together, you’re looking at around $100 to $195 to replace your serpentine belt.
Contents
How much does it cost to replace a serpentine belt on a Toyota Corolla?
Toyota Corolla Serpentine Belt Replacement Cost Estimate. Labor costs are estimated between $47 and $60 while parts are priced between $30 and $36. This range is based on the number and age of Toyota Corolla’s on the road.
Does Corolla have timing belt?
1998 or newer toyota corolla cars do not have timing belts – they have chains. However, corolla cars made between 1990 and 1997, use a timing belt that needs to be replaced every 60,000 miles.
When should I replace my serpentine belt?
Under ideal circumstances, your car’s serpentine belt should last 60,000–100,000 miles. It’s important to replace this belt as part of your vehicle’s scheduled maintenance (even if it looks okay) to avoid it breaking while you’re on the road.
When should a timing belt be replaced on a Toyota Corolla?
Most timing belts will need to be replaced as part of regular maintenance every 60,000 to 100,000 miles, and most related problems are caused by not replacing it when you’re supposed to. If the timing belt is starting to go bad, the engine will run poorly and the check engine light will likely come on.
How do you replace a serpentine belt on a 2010 Toyota Yaris?
How tight should a serpentine belt be?
The required measure of tension in the serpentine belt is that it should not deflect more than ½ inch when twisted either way from the middle. If twisted more, the belt is loose, and if twisted less, the belt is too tight.
How do you change the alternator on a 2010 Toyota Corolla?
What must you do before replacing a serpentine belt?
How far can you drive without a serpentine belt?
depending on your vehicle a serpentine belt runs your A/C, alternator, and power steering usually. You can go 1/2 a mile without that. But, in some cars it also runs your water pump.