Likewise, how do you reset the oil change light on a Jeep Wrangler? Without starting the engine, turn the ignition in the ON/RUN mode position. In the instrument cluster display, navigate to “Vehicle Info” then “Oil Life.” Push and hold the ‘OK’ button until the oil life gauge resets to 100%.
Also know, how do you reset the oil change light on a 2011 Jeep Wrangler?
Also, how do you reset the oil life on a Jeep Wrangler 14?
Additionally, how do you reset the oil light on a 2009 Jeep Wrangler?
- Turn the key to ON/RUN position with engine off.
- Fully depress and release the accelerator pedal 3 times within 10 seconds.
- Turn the key to the OFF position and then back on to confirm reset was accepted.
Hold the Reset Button and Turn the Key Turn the ignition back to the ON position while holding the reset button. Watch the oil change or maintenance light carefully. It should start to blink. Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.
Contents
Why is my oil change light still on?
If your oil light stays on even after changing your engine oil, you’re going to want to check the sensor first to rule out a malfunctioning sensor as the cause. Dirt and other particles can make their way into the oil pump, causing the sensor to falsely identify oil issues. … The next common cause is low oil pressure.
How do you reset the codes on a 2011 Jeep Wrangler?
- Make sure the engine is not running and key is out of the ignition.
- Disconnect the battery terminals.
- Wait 5 minutes.
- Reconnect battery terminals.
- Insert and turn the ignition key to the run position without starting.
- All error codes are cleared and CHECK ENGINE icon disappeared.
How do you reset the oil light on a 2012 Jeep Wrangler?
How do you reset the oil light on a 2015 Jeep Wrangler?
- Turn the ignition to run (one position before starting engine).
- Fully depress the accelerator pedal slowly three times within 10 seconds.
- Turn the ignition off and then start the engine to verify the indicator has been reset.
How do you reset the change oil light on a 2013 Jeep Wrangler?
Why does my Jeep says oil change required?
The engine oil change indicator system is duty cycle based, which means the engine oil change interval may fluctuate dependent upon your personal driving style. … Unless reset, this message will continue to display each time you turn the ignition switch to the ON position.
How do I reset my oil change light on my Jeep Grand Cherokee?
- Turn the ignition switch to the ON position, do not start the engine.
- Fully depress the accelerator pedal slowly three times within 10 seconds.
- Turn the ignition switch to the OFF/LOCK position.
How do I reset my Jeep Wrangler computer?
- Step 1 – Remove the positive (red) battery cable.
- Step 2 – Ground the red cable to the negative terminal.
- Step 3 – Reconnect the positive battery cable.
- Step 4 – Turn on your Jeep.
- Step 5 – Cycle the headlights.
- Step 6 – Turn the key off and remove.
How do you reset the change oil light on a Jeep Cherokee?
On the steering wheel, navigate to the “Oil Life” selection under “Vehicle Info“. Push and hold the OK button until the oil light percentage changes to 100%. Press the Start/Stop button to turn the electronics off.