Jeep Wrangler Serpentine Belt Replacement Cost Estimate. Labor costs are estimated between $45 and $57 while parts are priced between $55 and $67. This range is based on the number and age of Jeep Wrangler’s on the road.
Subsequently, when should I change the serpentine belt on my Jeep Wrangler? 5 years/75k miles seems like a good time to change it. Also whenever you replace the alternator or water pump. I had one fail on a Grand Cherokee V8 at 56k miles(!) but the JK 3.6 belt seems more durable.
Frequent question, how expensive is it to replace a serpentine belt? A typical serpentine belt start at around $25 and goes up to $75 at most. If you know some car repair basics, you could change the belt yourself, and it may save you paying labor charges somewhere between $75 and $120. All together, you’re looking at around $100 to $195 to replace your serpentine belt.
Best answer for this question, how do you change a serpentine belt on a Jeep?
Additionally, can I drive with a bad serpentine belt? Under no circumstances can you drive a vehicle without a serpentine belt because the serpentine belt serves the important function of delivering antifreeze to important parts of the engine. The serpentine belt drives the water pump, and without it, there is insufficient coolant flow to maintain the engine temperature.
Contents
Is timing belt same as serpentine belt?
The serpentine belt and timing belt have very different functions in your vehicle. The timing belt is located inside the engine and keeps the crankshaft and camshaft in sync. … The serpentine belt is what keeps the engine accessories running smoothly and efficiently.
How often do you change the serpentine belt?
How often does a serpentine belt need to be replaced? Serpentine belts are built to last—much longer than before because of advancements in rubber technology. Under ideal conditions, a belt should stick with you for an average of 60,000 to 100,000 miles.
How do you replace the idler pulley on a Jeep Wrangler?
How do you tighten the belt tensioner on a Jeep Wrangler?
How far can I drive with a broken serpentine belt?
How long will my car run with a broken serpentine belt? There are a few variables involved in the answer, but it should be able to run between 20 to 90 minutes. If it is a hot summer day, your engine can overheat very quickly without the coolant being pumped through the radiator.
What are the signs of a timing belt going bad?
- You Hear A Ticking Noise Coming From The Engine.
- Your Car’s Engine Won’t Turn Over.
- You Notice An Oil Leak Near The Motor.
- You Experience Exhaust Issues.
- Your Revs Start Acting Up.
How many years does a serpentine belt last?
Under ideal circumstances, you’ll get anywhere from 50,000 to 100,000 miles of reliable service from a typical serpentine belt. In terms of years, it may be anywhere from 4 years to an entire decade before you’ll need to replace your serpentine belt.
How tight should a serpentine belt be?
The required measure of tension in the serpentine belt is that it should not deflect more than ½ inch when twisted either way from the middle. If twisted more, the belt is loose, and if twisted less, the belt is too tight.