- Turn the ignition switch to the “ON” position without starting the vehicle.
- Press the gas pedal to the floor slowly three times within 10 seconds.
- Turn the ignition off. Wait 10 seconds and start the engine.
Beside above, how do you reset the perform service light on a 2004 Jeep Grand Cherokee?
Likewise, how do you reset the perform service on a 2007 Jeep Grand Cherokee?
You asked, why does my Jeep Grand Cherokee keep saying perform service? When the “Perform Service” indicator comes on, this lets you know your Jeep has reached its scheduled mileage for needing regular maintenance. This means you need to take it to a professional to have specific fluids swapped, tires rotated, or something similar.
Correspondingly, how do you reset the maintenance light on a 2000 Jeep Grand Cherokee?
- Turn the key to ON/RUN position with engine off.
- Fully depress and release the accelerator pedal 3 times within 10 seconds.
- Turn the key to the OFF position and then back on to confirm reset was accepted.
- Turn on the engine.
- On the vehicle’s dash, press the “Step” button until “Miles to Service” is displayed.
- Press and hold the “Reset” button, near the “Step” button, until the “Miles to Service” flashes and resets. Verify the “Perform Service” light goes away.
Contents
How do you reset the check engine light on a 2018 Jeep Grand Cherokee?
To turn off the Jeep Grand Cherokee check engine light, turn the ignition switch to ON but don’t start the vehicle. Press the gas pedal 3 times within 10 seconds and turn the ignition off. Wait 10 seconds and start the engine.
How do you reset the perform service on a Jeep Grand Cherokee?
- Turn the ignition switch to the “ON” position without starting the vehicle.
- Press the gas pedal to the floor slowly three times within 10 seconds.
- Turn the ignition off. Wait 10 seconds and start the engine.
To reset the tire pressure monitor or tpms system in your 2018 jeep grand cherokee vehicle, turn the ignition key to the “on” position and depress the tpms button, usually located under the dash, until the tpms light blinks several times.
How do you reset the transmission on a Jeep Grand Cherokee?
- Press the gas pedal down and keep it pressed.
- Turn ignition on without starting the engine.
- Keep ignition on (engine off) and the gas pedal pressed for 30 seconds.
- Turn the ignition off.
- Release the gas pedal.
What does the check engine light mean on a Jeep Grand Cherokee?
If the check engine light in your 2020 Jeep Grand Cherokee starts flashing, that means that the problem needs immediate attention and your Jeep should be transported in shortly. This blinking light usually indicates a severe engine misfire allowing unburned fuel to be dumped into the exhaust system.
How do I reset my performance service?
How do I reset my Jeep Cherokee computer?
- Disconnect the battery by removing the positive battery cable.
- Ground the positive cable to the negative cable for 30 seconds to erase the electric charge in the capacitors.
- Reconnect the positive cable to the battery.
- Turn the key to on but do not start.
- Turn the headlights on.
How do you reset the service light on a 2008 Jeep Grand Cherokee?
What would cause a Jeep Cherokee to not start?
While there are a variety of reasons your Jeep Cherokee won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter.