Amazingly, how do you reset the perform service on a Jeep Grand Cherokee?
- Turn the ignition switch to the “ON” position without starting the vehicle.
- Press the gas pedal to the floor slowly three times within 10 seconds.
- Turn the ignition off. Wait 10 seconds and start the engine.
As many you asked, why does my Jeep Grand Cherokee keep saying perform service? When the “Perform Service” indicator comes on, this lets you know your Jeep has reached its scheduled mileage for needing regular maintenance. This means you need to take it to a professional to have specific fluids swapped, tires rotated, or something similar.
Also the question is, how do you reset the perform service on a 2006 Jeep Grand Cherokee? Locate the “Step” button on the Grand Cherokee’s instrument panel and press it. Press it again until it says “Miles to Service.” Press in and hold the button for about five seconds. It should read “Reset.” This will turn off the service light on the display.
You asked, how do you reset the perform service on a 2004 Jeep Grand Cherokee?
To reset the tire pressure monitor or tpms system in your 2018 jeep grand cherokee vehicle, turn the ignition key to the “on” position and depress the tpms button, usually located under the dash, until the tpms light blinks several times.Contents
How do I reset my jeep dashboard?
- Turn the ignition switch to the “ON” position without starting the vehicle.
- Press the gas pedal to the floor slowly three times within 10 seconds. Turn the ignition off. Wait 10 seconds and start the engine.
How do I reset my performance service?
How do I reset my Jeep Cherokee computer?
- Disconnect the battery by removing the positive battery cable.
- Ground the positive cable to the negative cable for 30 seconds to erase the electric charge in the capacitors.
- Reconnect the positive cable to the battery.
- Turn the key to on but do not start.
- Turn the headlights on.
How do you reset the service light on a 2008 Jeep Grand Cherokee?
What does perform service mean on 2006 Jeep Grand Cherokee?
Needs to perform the manufacturer’s suggested maintenance service. It could be as simple as an oil and filter change – based on mileage and previous maintenance records. After the service the repair shop will reset the warning light.
Depress the TPMS button located under the steering wheel until it flashes three times. Start the engine and idle for 20 minutes while the system records and stores the PSI of each wheel. Alternatively, You may disconnect the positive battery cable for 15 minutes and reconnect.
How do you clear the error code on a Jeep Grand Cherokee?
- Pull the release lever to open the hood from inside the vehicle.
- Open the hood and place the support rod into position to prop up the hood.
- Remove the nut connecting the negative battery terminal to the battery, using an open end wrench.
- Allow the computer to reset.
How do you reset the TPMS 2020 Jeep Grand Cherokee?
Locate the TPMS reset button under the steering wheel and press in, holding until the tire pressure light blinks three times. Start the car and wait 20 minutes for the sensor to refresh. Inflate all tires to 3 PSI over their recommended amount, then deflate them completely.
The TPMS reset button is usually located beneath the steering wheel. If you are unable to find it, refer to your vehicle’s owner’s manual. Inflate all tires to 3 PSI over their recommended amount, then deflate them completely. Be sure to include the spare tire, as it may have a sensor as well.
How do you reset the tire pressure monitoring system on a 2013 Jeep Grand Cherokee?
To reset the tpms on the 2013 jeep grand cherokee, hold down the tpms reset button until the tire pressure light blinks, start the vehicle and wait around 20 minutes.