Switch the ignition ON, the SRS light will appear for six seconds then OFF for four seconds. When the light goes OFF, REMOVE the paperclip. When the light comes ON, put the paperclip back IN. Once more, when the light goes OFF, REMOVE the paperclip.
Likewise, how do you turn the SRS light off?
- Put the key into the ignition and turn the switch to the “on” position.
- Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
- Repeat Steps 1 and 2 two more times.
Also know, how do you bypass the SRS light on a Honda?
Also, how do you reset the SRS light on a 2002 Honda Odyssey?
People ask also, how do you turn off the airbag light on a 2005 Honda Odyssey? Place the key into the ignition and turn it on, but don’t allow the engine to turn over while still holding the wires together. Watch as the SRS light blinks on then turns off. Separate the wires right away and the SRS light will turn back on.If the SRS light stays on or starts flashing on and off, you may have a problem with the airbags themselves, a loose wire, a faulty seat belt buckle, or a problem with the Engine Control Unit (ECU) that is causing the airbag warning light to stay on.
Contents
How much does it cost to fix SRS light?
What is typical cost to resolve an illuminated Supplemental Restraint System (SRS) Warning Light? Expect to pay between $100 to $200 for the initial diagnostic.
How do I reset my Honda SRS light?
- There is a yellow plug under the dash plugged into the fuse panel.
- Turn the ignition key to the “ON” (II) position.
- When the SRS light comes back on plug the jumper wire back in within 4 seconds the light will blink twice and go out.
- Unplug the jumper and turn the ignition key off.
How do I reset my Integra SRS light?
Will disconnecting battery reset airbag light?
Often, all it takes to get rid of that pesky warning light is to reset your airbag sensor. … Remove the terminal clamp and leave it disconnected for 5-10 seconds to allow the airbag sensor to reset. Then reconnect the battery terminal and turn the vehicle on. With a bit of luck, the light will stay off.
Why is my SRS light on in my Honda Odyssey?
The SRS (Supplemental Restraint System) Warning light on the Honda Odyssey is designed to only come on after the vehicle has been in an accident. If the light comes on otherwise, then there is a problem with the internal diagnostic system.
How do you reset the SRS light on a 2003 Honda Odyssey?
Place the key into the ignition and turn it on, but don’t allow the engine to turn over while still holding the wires together. Watch as the SRS light blinks on then turns off. Separate the wires right away and the SRS light will turn back on.
Where is the fuse for SRS light?
The fuse block is on the driver’s side of the engine compartment. Pull out the SRS fuse. In most models, this is fuse #40, located in the lower right corner of the fuse block.
How do I turn off the airbag light after an accident?
What is a SRS light?
If the SRS light illuminates while you are driving, it signals there’s an issue with the car’s airbag system. It also means that the airbags may not deploy if you’re in an accident. If the light comes on, take your car to get the SRS sensor checked as soon as possible.
What does TCS mean on a Honda Odyssey?
Page 1. Your Honda is equipped with a Traction Control System (TCS) to assist you in maintaining traction while driving slowly on loose or slippery surfaces. The TCS assists only in low-speed, low-traction conditions; up to approximately 18 mph (30 km/h). TCS monitors the speed of all four wheels.