Turn the ignition to the ON position. Do not start the engine. Press and release the “Select/Reset” stem button on the instrument panel to toggle the options until the “Hold Reset For Setup Menu” option appears. Press “Select/Reset” to toggle the options until the “Hold Reset if New Oil” option appears.
Likewise, how do you reset the oil change light on a 2014 Ford Explorer?
- Switch the ignition over to the on position.
- Go to the SETTINGS menu.
- Scroll and select VEHICLE.
- Scroll down to OIL LIFE RESET.
- Press and hold the OK button.
- Shut the vehicle off and then start it back up and check the oil change light should be gone.
People ask also, how do you reset the oil light on a 2015 Ford Explorer?
Also know, how do you reset the oil light on a 2011 Ford Explorer? To reset the ford explorer oil life light, put the ignition into on without starting engine. Use the pad on the steering wheel to scroll through the settings. Go to settings, vehicle, oil life reset. Push and hold ok.
Also, how do you reset the change oil light on a 2013 Ford Explorer?
To reset the oil level warning or maintenance light in your 2012 ford explorer vehicle, turn the ignition key to the “on” position and depress the gas pedal slowly three times. Release and start your vehicle and oil light should indicate a reset.Contents
How do you reset the oil light on a 2010 Ford Explorer Sport Trac?
What kind of oil does a 2011 Ford Explorer take?
The approved oil type for the 2011 Ford Explorer 4.6L and 4.0L is the SAE 5W-20 and 5W-30 displaying the API Certification Seal. The engine oil capacity for the 2011 Ford Explorer is 6 and 5 US quarts.
How do you reset the oil light on a 2007 Ford Explorer?
How do you change the oil on a 2010 Ford Explorer?
Can 5w30 be used instead of 5w20?
Can You Use 5W-30 Instead of 5W-20? In theory, yes, you can switch from using 5W-20 to the 5W-30 because they have similar viscosity ratings. In fact, often, when you take your car to a mechanic for an oil change, they’ll put the 30 instead of the 20 because it’s thicker.
What kind of oil does Ford Explorer use?
The 2019 Ford Explorer uses SAE 5w-30 viscosity, fully synthetic motor oil in its 2.3 liter, inline-4 engine. The vehicle has an oil capacity of 6 US quarts.
What is the towing capacity of a 2011 Ford Explorer?
Fully equipped, the new Explorer can tow 5000 pounds, down from the 7115-pound rating of the 2010 V-8 model. Towing capacity for the four-cylinder is 2000 pounds, enough to haul a Jet Ski or a snowmobile but not much more.
How do I reset my Ford Explorer?
- Open the hood: release the primary latch by pulling the release lever under the steering wheel near the floor board.
- Disconnect the negative battery terminal.
- Wrap the negative clamp in a towel.
- Leave the negative battery cable off for a minimum of five minutes.
What does the wrench light mean on a 2007 Ford Explorer?
The wrench light on a 2007 Ford Explorer means that it is time for a service on the vehicle. Usually it will be something simple like an oil change, but could be more involved like a transmission fluid change. It is impertinent to always keep up on the maintenance with Your vehicle.
How do I reset the oil light on a 2006 Ford Explorer?
Depress the “TRIP/RESET” button then select “OIL LIFE RESET.” The message display will show “HOLD RESET IF NEW OIL.”Press and hold the “TRIP/RESET” button for more than two seconds to reset the engine oil life. Once the procedure has been completed, “OIL LIFE SET TO 100%” will be displayed.