Likewise, how do you reset the service light on a Ford Explorer?
Also, how do you reset the oil life on a 2007 Ford Explorer?
- Press the SETUP button until the display reads “Press Reset To Begin System Check”
- Press the RESET button to display “Hold Reset If New Oil”
- Press and hold the RESET button for 2 seconds and release.
- The oil life is now set to 100%
People ask also, how do you reset the oil change light on a 2009 Ford Explorer?
Also know, will check engine light reset itself? Your vehicle’s check engine light will will reset by itself once the issue or problem has been repaired; this is true for most models. … If you are certain that you have resolved the issue that caused your check engine light to come on in the first place, then the light should reset itself after at least 20 cycles.
- Switch the ignition over to the on position.
- Go to the SETTINGS menu.
- Scroll and select VEHICLE.
- Scroll down to OIL LIFE RESET.
- Press and hold the OK button.
- Shut the vehicle off and then start it back up and check the oil change light should be gone.
Contents
What does the wrench light mean on a 2007 Ford Explorer?
The wrench light on a 2007 Ford Explorer means that it is time for a service on the vehicle. Usually it will be something simple like an oil change, but could be more involved like a transmission fluid change. It is impertinent to always keep up on the maintenance with Your vehicle.
How do you reset the oil change light on a Ford?
Press and hold the trip/reset button until the display reads “OIL LIFE SET TO 100%.” Turn the ignition to the “OFF” position. Start the engine and verify that the oil change required message is no longer displayed.
How do you reset the oil change light on a 2010 Ford Explorer?
- Press and hold the SELECT/RESET stem for more than two seconds. Oil life is set to 100% and OIL LIFE SET TO 100% is displayed.
- Once OIL LIFE SET TO 100% is displayed, release, press and hold the.
- After setting the oil life start value, press the SELECT/RESET stem.
What does the wrench light mean on a 2010 Ford Explorer?
If You see the wrench light turn on in the dash of Your 2010 Ford Explorer this means that Your ECU has detected a fault. I recommend getting off the road as soon as possible because continuing to drive can cause more damage to Your SUV.
How do you reset the oil change light on a Ford Explorer Sport Trac?
- Turn the ignition to run, one position before starting engine.
- Press and hold the OIL CHANGE RESET control for 5 seconds. The message centre will count down for 5 seconds and the message centre will display OIL LIFE RESET TO 100%.
Will Autozone reset check engine light?
Did you know that you can get your check engine light scanned for free? Any of the major parts stores in the country, such as: Napa, Advance Auto, Autozone and O’Reilly’s, will scan your vehicle, and tell you the P codes for no charge at all.
How do I reset my check engine light without a scanner?
How long do I have to drive to reset OBD?
To make sure the check engine light does not reappear, it’s recommended that you drive your car 30 to 100 miles. This enables the vehicle’s “Drive Cycle” to reset, as the various sensors need time to recalibrate.
How do you reset the oil change light on a Ford Explorer?
To reset it, go ahead and turn Your ignition to the ON position but do not start the engine. Now, on Your cluster, press the Select button and head to Set Up Menu Hold Reset. Hold the Select button for around 3 seconds and then let it go. Press the Select button again until You get to Hold Reset If New Oil.
How do you reset the check engine light on a 2012 Ford Explorer?
Insert the key into the ignition to do this, turn the car on for about a second, then off for about a second. Do this two times more then drive the car as normal. This can be done by putting the car on and back off three times in quick succession.