- Get in and close all doors.
- Within 30 seconds of turning the ignition off, hold down the “unlock” button and press the “lock” button three times.
- Quickly put the key back in the ignition and turn it on/off again to finalise.
Also know, how do you reset a Range Rover?
- Go to Settings menu.
- Select “Backup & Reset”, select “Factory data reset”
- Select “Reset phone” and “Erase everything”
- The device will then reboot.
People ask also, how do I reset my battery after replacing it? Switch off your vehicle and unplug all fuses once it has completely warmed up, then detach the battery to cut power. All of the old data should be reset after a few minutes, so reconnect the fuses and restart your engine.
Likewise, how do you reset a Range Rover Sport?
Also, how do you reset a Land Rover Discovery battery? In brief, to start the hard reset process, open the hood but close all doors and let your 3 go to sleep – no radio display etc and no key in the ignition. This will take a couple of minutes and do not open any doors until the reset is completed.Youtube video link: https://m.youtube.com/watch?v=LH543AsJ5aI
Contents
How do you clear the code on a Range Rover?
- use a code reader.
- disconnect the battery leads for a couple minutes.
- cycle the key on and off more than 40 times. Note, this one requires the problems to be fixed before it worksthe other 2 ways do not, although the codes will return in 2 trips, otherwise.
Do I need to reset car after changing battery?
Yes. You will need to reset your settings. Usually the dealer can do it free of charge but no promises. If you take a battery off and put a new one on, if there was anything hooked up the the battery, i.e. the hose you are speaking of, reinstall it.
Do you have to reprogram car after changing battery?
Changing the battery has nothing to do with programming a battery. … The key fob will lose programming to the computer as the vehicle computer is reset. However, if a 9 volt battery saver was put into a cigarette lighter and the car battery was removed, then the computer will not lose its memory and be just fine.
Does replacing car battery reset computer?
In many cars, however, you can reset car computer after replacing battery to delete not only diagnostic trouble codes, but also drivability, security, and radio codes. Before disconnecting the battery, locate any codes and have them, as well as the drivability learning procedures, on hand.
How do you put a Range Rover in service mode?
How do I reset my Range Rover Smart Key?
Position the Smart key flat against the side of the steering column. There are markings on the steering column to help locate the correct position. While holding the Smart key in position, firmly press and hold the brake pedal. Press and release the engine START/STOP button.
How do you reset the suspension on a 2006 Range Rover Sport?
How do I reset my ECU?
What does gearbox fault mean on a Range Rover?
The gearbox fault message is often triggered by insufficient battery voltage. It’s a strange sort of Land Rover code – you know, gearbox fault REALLY means battery bad.