Turn the jack lever (2) clockwise to raise the jack, until it locates into the jacking point. Make sure that the base of the jack is in full contact with the road surface. Raise the vehicle with the jack, until the tyre being lifted just clears the ground. Operate the jack with a slow and steady motion.
Likewise, how do you lock the air suspension on a Range Rover? 2016 Range Rover Make sure that the suspension height is set at the access height setting or the normal height setting. Make sure that the vehicle is travelling at a speed of less than 35 km/h (22 mph). Press the down button (2) for longer than 1 second, to lock the vehicle at access height.
Also, where do you jack up a Range Rover? To raise the vehicle, use the jacking points located on the front and rear of the side tubes, fixed side steps, or deployable side steps.
Also know, how do you reset the air suspension on a Range Rover?
People ask also, how do I put my Range Rover Sport into access mode?
The design of the air suspension in the Land Rover is impressive. The suspension is controlled electronically and allows the driver to make adjustments. The way the suspension is able to adjust is by a compressor connected to each individual air strut. The air suspension really does make for a smoother and better ride.Contents
How do you jack up a Land Rover lr3?
How do you jack up a Land Rover Discovery sport?
Fit the wheel nut brace to the end of the cranking lever. Rotate the handle clockwise to raise, until the jack pin locates into the jacking point. Continue raising the vehicle until the wheel is clear of the ground. Remove the wheel nuts and place them together where they cannot roll away.
Where are the jacking points on a Range Rover Evoque?
To assist in raising the vehicle, use the customer jacking points on the sill or on the trolley jack position at the rear of the front subframe as indicated in the following illustrations. WARNING: Always chock the rear wheels when jacking the front of the vehicle.
How do you raise the suspension on a Range Rover?
- Press and hold to raise the rear suspension.
- Press and hold to lower the rear suspension.
- Simultaneously press and hold both buttons to set the rear suspension to the normal height setting. A time delay may be evident before the vehicle reacts to a suspension height request via the buttons.
Can you drive a Range Rover with suspension fault?
Owning a Land Rover with Air Suspension is a smooth and comfortable ride until this Suspension Fault message appears. … This message does mean the electronic air suspension has stored a suspension fault but you can still drive normally on the freeway and surface streets.
What does it mean when my Range Rover says suspension fault?
If the fault becomes active when the suspension is at “normal” height, the suspension is locked, preventing it from raising or lowering with a warning message “Normal Height Only”. If the suspension is lowered when the fault becomes active, it fails to raise and the warning message to not exceed 35 MPH is shown.
How do you raise and lower the suspension on a Range Rover?
If a door is open, press and hold to raise the suspension height. The button’s LED indicator lamp illuminates during suspension height adjustment and extinguishes when complete. Down button: Press and release to lower the suspension height. If a door is open, press and hold to lower the suspension height.
How do you turn on auto access height on a Range Rover?
Auto access height automatically lowers the electronic air suspension to the access height setting when the vehicle is parked. See ACCESS HEIGHT. Auto access height is enabled or disabled via the Vehicle Settings instrument panel menu. See INSTRUMENT PANEL MENU.
How do I set the height on my Range Rover?
To lower the vehicle to the full access height setting, press the down button (2). The full access height setting is 40 mm below the normal height setting. Auto access height can be activated until 90 seconds after the vehicle becomes stationary.
How do you jack up a Range Rover Sport with air suspension?
Turn the jack lever (2) clockwise to raise the jack, until it locates into the jacking point. Make sure that the base of the jack is in full contact with the road surface. Raise the vehicle with the jack, until the tyre being lifted just clears the ground. Operate the jack with a slow and steady motion.