To reset the tailgate on your vehicle, keep pressing and holding the rear liftgate close button until you hear it beep at least four times. You can only see this button when your liftgate is opened, and it is present on the door jamb of the back gate.
Likewise, how do I reset my Subaru liftgate? With the liftgate open and not moving, press and hold the rear liftgate close-button until it beeps 4 times (button is located on the door jamb of the rear liftgate, and only accessible when the liftgate is open). Continue to hold until it beeps again, and then let go. Close the liftgate.
Correspondingly, why is my power liftgate not working? The most common liftgate issues can be traced back to the motor or motor start solenoid. … Using a small jumper cable, bypass the solenoid by putting direct power to the motor to see if it will run. If it doesn’t, safely check and replace any broken fuses or reset breakers.
Also know, how do I fix the hatch on my Subaru Outback?
Similarly, how do I reset my Subaru boot?
- With your key fob in your hand, pocket or bag, approach the liftgate.
- The logo projection will automatically turn on as you get within 6 feet of the rear of your vehicle.
- Kick straight over the logo, or at the sensor for older vehicles.
Contents
Why does my Subaru Outback battery keep dying?
CSK&D is investigating reports that 2016-2020 Subaru Outback and 2019-2020 Subaru Ascent vehicles experience random liftgate openings and other electrical issues which cause the batteries in these vehicles to rapidly drain. This often occurs overnight or during intervals of non-use.
How do you test a liftgate actuator?
- Test the Power Liftgate Button on Key Fob. Press the other buttons on the key fob like the lock and unlock buttons to confirm there is no issue with the remote key.
- Confirm the Automatic Liftgate Switch Is Not Turned Off. Automatic liftgate switch in the ON position.
Can you manually close a power liftgate?
A power liftgate is a motorized hatch that opens and closes electronically. … Automakers have also added a way to disable power operation if you prefer to close the hatch manually.
Can you manually open a power liftgate?
When operating the power liftgate after you have programmed a lower height than fully open, you can fully open the liftgate by manually pushing it upward to the maximum open position.
How do you reset the trunk height on a Subaru Outback?
Go to the back of the car once more, and press and hold the close button for 3-4 seconds. You’ll hear an Audible tone to confirm Your memory. Press the set memory button next to the steering wheel and then manually unlatch the liftgate and raise it to your preferable height.
Why is my Subaru Outback Trunk not opening all the way?
How do you manually open the hatch on a Subaru Outback?
How do you adjust a rear tailgate?
How do you reset the tailgate power on a Subaru Forester?
Disconnect the positive and negative cables from the vehicle’s battery, touch the 2 cable ends together creating a capacitive discharge which will clear the memory. Reconnect the cables to the battery, reset all radio presets (and navigation favorites, if applicable) then confirm normal PRG operation.
How do I turn off power liftgate?
The PWR DOOR OFF switch in the glove box must be in the ‘operate’ position for the liftgate to be operated in power mode. To open the liftgate using the switch on the instrument panel, press and hold the switch until you hear a tone and the liftgate opens. To stop it, press again.