To reset the oil life warning or maintenance light in your 2017 subaru outback vehicle, turn the ignition key to the “on” position and depress the gas pedal slowly three times. Release and start your vehicle and the oil light should indicate a reset.
Furthermore, how do you reset the service reminder on a subaru outback?
- From the main screen of the display, select “Car Info“.
- Select “Maintenance“.
- Tap “Engine Oil“.
- Select “Notification Date” and/or “Notification Distance“.
- Repeat the steps to also change “Maintenance Schedule“, “Oil Filter“, and “Tires“.
Subsequently, how do you reset the maintenance light on a 2016 subaru outback? First, turn the ignition to ON (with the engine not running), and select CAR INFO on the navigation system. Select MAINTENANCE. Next, delete any maintenance event that has been completed, and click ADD EVENT, and configure the date and miles of the maintenance interval schedule. Finally, touch FINISH.
Also, how do you reset the oil life on a 2017 subaru Legacy? Pull and hold the center button until You see the maintenance menu. Choose engine oil from the options. Press set. Next, press the knob down and hold it for a few seconds before resetting the screen back to 100%.
Quick Answer, how do I reset my subaru outback?
- Open the hood of your Subaru and loosen the nut that holds the cable clamp to the negative battery terminal.
- Slide the cable off the negative battery terminal.
- Wait 5 minutes, then reconnect the cable and tighten the retaining nut.
An oil change is one of the most capable and vital services for your car. Subaru recommends getting your 2017 Subaru Outback oil & filter changed every 3,000-5,000 miles, but it’s best to check your owner’s manual and with your dealer to find out the intervals that work best for your vehicle.
Contents
How do you reset the maintenance light on a 2015 Subaru Outback?
To reset the oil light in a 2015 Subaru Outback turn the key in the ignition to ON. Pull the i/SET switch towards You and hold it until the selection screen appears. Locate and highlight Maintenance by using the up and down arrows. Pull the i/SET switch again.
What oil does a 2017 Subaru Outback take?
2017 subaru Outback Oil 5W30 Synthetic.
How do you reset the oil light on a 2018 subaru outback?
To reset the change oil light, simply turn on the ignition to run but don’t start the engine. Then use the left hand side controls on the steering wheel to select the up or down arrows until you highlight the maintenance menu. Then pull the i/set switch toward you which triggers the reset process.
How do you reset the oil light on a 2017 subaru Forester?
How do you reset the oil life on a 2019 subaru outback?
- Turn on the ignition don’t start the engine.
- Press the CAR INFO on the MULTIMEDIA NAVIGATION SYSTEM.
- Then select MAINTENANCE.
- Select ENGINE OIL.
- Select and SET “Notification Date” or “Notification Distance” of the reminder.
- Click SET.
- Close menu.
How do you reset the oil light on a subaru?
To perform an oil reset on the subaru outback you need to turn it on, but do not start the engine. Find the reset button on the console dash and hold it. When the light blinks and stops turn the vehicle off and wait 5 min. Your oil is now reset.
How do you reset the oil life on a 2017 subaru Impreza?
How do I reset my Subaru Starlink?
The Subaru Starlink infotainment system can be rebooted by pressing and holding the power button for at least 15 seconds. If You are looking to perform a factory reset go into the Settings menu on Your display screen then select “Factory Data Reset”.