Take the cap off the low-pressure fitting, and put it in a safe place. Shake the bottle of refrigerant for one minute, and place the end of the hose on the low-pressure fitting. Press the button on the can to release the refrigerant and fill your system.
Also, how do I recharge the AC in my Ford Explorer?
Likewise, where is the low pressure port on a 2013 Ford Explorer? The low pressure port is in the low pressure line from the evaporator through the accumulator/drier to the compressor on the right side of the rad (from the driver’s perspective).
Also know, what kind of refrigerant does a 2013 Ford Explorer take? 2013-11 10 Cyl. 6.8 Eng.; w/o Rear AC – 30.00 Oz. R-134a; 8.00 Oz. PAG-46 .
People ask also, how do you reset the AC on a Ford Explorer? First You should turn Your SUV on and then press and hold the AC and heater buttons at the same time and then release them and press the heater button until the reset is complete. Usually this will fix most of the problems with the HVAC system in Your SUV.
Contents
How much freon does a Ford Explorer need?
The 2016 Ford Explorer has a total freon capacity of 44.96 ounces, and uses R-134a refrigerant.
Why is my Ford Explorer not blowing cold air?
If your car’s air conditioning isn’t blowing cold air at all (or it tries, then turns warm), you could have a clogged expansion valve, a faulty compressor clutch, a leak, or a malfunctioning fuse in the system.
Why is my Ford Explorer AC not working?
While there are a variety of reasons your Ford Explorer air conditioning won’t work, the most common 3 are a refrigerant leak, an electrical climate control issue, or a problem with the air conditioning compressor.
What is wrong with the Ford Explorer?
The 2016 Explorer has engine trouble, transmission problems, drive system issues, and more. There are also tons of problems reported about the 2020 Ford Explorer, including electronic problems, power equipment issues, transmission problems, minor engine trouble, and more.
What is the low side of an AC system?
The low side, or suction line, will be the line connected to the compressor from the top or higher position. It will be cold to the touch and may be wrapped with insulation. This is where freon enters the compressor as a gas.
Where is the low pressure valve for air conditioner?
The low side service valve is located in the line that runs from the compressor through the evaporator (firewall) and up to the condensor on the low pressure (suction) side of the system.
Do you fill AC on the high or low side?
Every auto air conditioning system has two service ports: one on the high pressure and one on the low pressure side. When recharging with AC Avalanche refrigerant, for safety, you will charge through the low side service port. Never charge through the high side port.
How much freon does a 2013 Ford f150 take?
The freon capacity in a ford f-150 is between 2 and 2.5 Pounds.
How much freon does a 2013 Ford Focus take?
To recharge the ac in a 2013 ford focus you will need 26 ounces of r134a refrigerant and a refrigerant exchange machine. Attach it to the high and low pressure sides and then add the freon.
What refrigerant does Ford use?
1 All 1999 – 2016 Ford, Lincoln, and Mercury vehicles are equipped with R-134a refrigerant. 2 The refrigerant usage applies to all models of a vehicle unless otherwise specified.