1. Stop the vehicle.
2. Adjust the cold tire pressure in all four tires recommended on the tire placard.
3. Press MENU button to enter the main menu.
4. Go to the VEHICLE INFO.
5. Select VEHICLE STATUS.
6. Select Tire RESET.
7. Starting the engine.
Contents
How do you reset the tire pressure light on a BMW?
1. Start engine.
2. Hold turn signal lever in the up or down position until TPMS telltale symbol and RESET are displayed.
3. Press button at end of turn signal lever.
4. Press and hold button at end of turn signal lever until a check appears after RESET.
5. Vehicle must be driven to complete relearn.
How do you turn off the low tire pressure light on a BMW?
After filling your tires you will need to reset your tire pressure monitor. From the home menu click car, vehicle status, tire pressure monitor, and tire settings. With the car stopped, and the engine running select perform reset. You will need to go on a short drive for the reset to be completed.26 déc. 2019
steering wheel
How do you reset the TYRE pressure light on a BMW 3 Series?
How do I reset my BMW service?
Locate the small odometer button near the bottom left corner of the instrument panel. Press and hold it until the service message appears. Release the button, and press and hold it again until the message says “Reset?”.
How do I reset the TYRE pressure warning light?
Without starting the car, turn the key to the “On” position. Press the TPMS reset button and hold it until the light blinks three times, then release it. Start the car and let it run for 20 minutes to reset the sensor. You’ll usually find the tire pressure monitor reset button beneath the steering wheel.
How do you reset the TYRE pressure light on a BMW 1 Series 2019?
Why is my tire pressure light still on after filling tires?
Quick Tip: If the TPMS warning light comes back on after you’ve filled the tire with air, recheck the tire to make sure it is inflated to the proper air pressure. If the tire air pressure is low, you have an air leak and should have the tire fixed or replaced.30 déc. 2015
What does the exclamation mark mean on a BMW?
Steering System: A steering wheel with an exclamation mark means there is an issue with your steering system. It could also mean that power steering is unavailable. Tire Pressure Monitor: The pictured symbol can show in yellow or red.
Why is my low tire pressure light on but tires are fine?
In most cases, the warning light may be triggered by a tire that is 10% to 15% low in air pressure. Cold or icy weather also has a tendency to lower the air pressure inside the tires. Taking the car for a short drive will heat up the tires and increase the tire pressure.30 jui. 2021
How long does it take for TPMS to reset?
The TPMS reset button should be held until the light blinks three times. If you want to reset the sensor, start the car and let it run for 20 minutes. The tire pressure monitor reset button can be found under the steering wheel.
Why is my TPMS not working?
TPMS problems can include any of the following: … The TPMS module itself is not functioning properly or has failed because of a voltage supply, wiring or internal electronics fault. • The tires were serviced or rotated recently and the relearn procedure was not done correctly.
What is the TYRE pressure for a BMW 3 Series?
35-38 psi