Chevrolet Equinox

How do you reset the anti theft system on a chevy equinox?

To deactivate the anti-theft system use the unlock button on the remote key. Unlock the driver’s door using the key and then switch the ignition switch to the on position. If that doesn’t work exit the vehicle and roll up all windows, then use the key to lock the driver’s door.26 oct. 2019

Contents

How do you reset the anti-theft system on a 2013 Chevy Equinox?

1. Turn ON the ignition, with the engine OFF.

2. Attempt to start the engine, then release the key to ON.

3. Observe the SECURITY telltale.

4. Turn OFF the ignition, and wait 5 seconds.

5. Repeat steps 1-4 two more times for a total of 3 cycles/30 minutes.

6. Start the engine.

How do I turn off anti-theft system?

In order to deactivate the anti-theft system, car owners must press the unlock button located on the remote key. So it is suggested to use the key to unlock the door, then change the switch of ignition to “on” position.24 déc. 2020

How do you reset a Chevy theft deterrent?

To reset the anti-theft system on the Chevy Silverado You will need to get into the car and lock the doors. Now with the doors locked put the key into the ignition and turn it to the on position. Let it sit there for 5 minutes until the anti-theft light blinks.

Can anti-theft stop car from starting?

Anti-theft systems are designed to prevent your vehicle from being stolen. These systems are constantly evolving. Essentially, they work via an electrical circuit disconnecting to prevent power from flowing so your car won’t start or will die immediately.3 jui. 2016

How do I get my car out of anti-theft mode without remote?

1. Close all of your car doors.

2. Insert one key in the door lock and cycle it to the “Lock” position, and then back to the “Unlock” position two times.

3. Enter your car and insert your key into the ignition cylinder.

4. Cycle the key in the ignition from the “Off” position to the “On” position twice in a row.

Why does my car says theft attempted?

THEFT ATTEMPTED This message displays if the content theft-deterrent system has detected a break-in attempt while you were away from your vehicle.

Does anti theft light drain battery?

To answer your question, NO, it’s highly unlikely that the anti theft will kill your battery.10 jui. 2019

What does service theft deterrent system?

The Servicegard universal theft deterrent system prevents unauthorized use of your vehicle by disabling the vehicle starter, fuel, or ignition system. … The system automatically activates to protect your vehicle when the ignition is turned off. It emits soft chirps to indicate it’s armed, disarmed, or in valet mode.

How much does it cost to reset anti theft system?

The Best in Auto Repair The average cost for antitheft system diagnosis & testing is between $44 and $56. Labor costs are estimated between $44 and $56. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.

Where is the anti-theft fuse located?

Is there a fuse for anti theft system? The alarm fuse is located in the fuse panel of most cars. Using the owner’s manual remove the fuse which will power down the security system. At this point the car will not start, reinsert the fuse to reactive the system.1 mar. 2021

How do I get my Mustang out of theft mode?

To reset the anti-theft on the vehicle You will need to first get into the vehicle and shut the doors. With the doors shut You want to put the key into the ignition slot and turn it on. Once You have turned it on You will then want to turn it back to the off position.

What triggers theft deterrent system?

The theft-deterrent system in your vehicle may be triggered by the following: Key learning (copy of key made) Forced entry alarm (door, trunk, hood) … Charging alarm (electric vehicles only)

How can I bypass pass theft deterrent system?

1. Leave the ignition key turned to the “On” position after the vehicle has stalled and will not start.

2. Look at the dashboard and locate the theft system light.

3. Turn the ignition to the “Off” position to disable the PassLock system, and wait for 20 seconds for the system to reset.

What does it mean when the anti-theft light is blinking?

Your car has a built-in anti-theft system. … The Anti-theft Light in the dash of your car should flash periodically to show that the system is engaged and active. Tip. You have to lock the doors of the car (without it running) for the alarm to engage.15 déc. 2015

See also:   Where is the pcv valve on a 2010 chevy equinox?
Back to top button

Adblock Detected

Please disable your ad blocker to be able to see the content of the page. For an independent site with free content, it is literally a matter of life and death to have ads. Thank you for your understanding!