1. Turn the ignition key to the “ON” position without starting the engine.
2. Press the Remote Keyless Entry (RKE) transmitter’s LOCK and UNLOCK buttons simultaneously for five seconds.
3. Activate the TPMS sensor.
Contents
How do you reset the tire pressure sensor on a 2008 Chevy Equinox?
Press and hold unlock and lock buttons on the keyless entry transmitter until horn sounds and left turn signal is illuminated. Or using the DIC, press and release INFO button until TIRE LEARN message is indicated on display. Hold down SET/RESET button until horn sounds and left turn signal is illuminated.25 juil. 2013
How do you reset the tire pressure sensor on a 2015 Chevy Equinox?
steering wheel
Why is my tire pressure light on when my tires are fine?
TPMS Light stays on all the time This could either mean air pressure in one or more of your tires is low. If you have already checked and know that this isn’t the case, then it could indicate that the TPMS sensor is not reading correctly.10 mar. 2021
Why is my TPMS not working?
TPMS problems can include any of the following: … The TPMS module itself is not functioning properly or has failed because of a voltage supply, wiring or internal electronics fault. • The tires were serviced or rotated recently and the relearn procedure was not done correctly.
How do you reset tire pressure monitoring system?
Without starting the car, turn the key to the “On” position. Press the TPMS reset button and hold it until the light blinks three times, then release it. Start the car and let it run for 20 minutes to reset the sensor. You’ll usually find the tire pressure monitor reset button beneath the steering wheel.
What is the best TPMS relearn tool?
1. VXDAS EL-50448 TPMS Tool for GM – Editor’s Pick.
2. JDIAG 2IN1 EL50448 TPMS Relearn Tool for GM and Ford.
3. Autel MaxiTPMS TS501 TPMS Programming Tool.
4. VXSCAN El-50448 Auto TPMS Reset Tool.
5. ATEQ VT31 TPMS Reset Activation Programmer Tool.
6. Autel TS408 Handheld TPMS Service Tool.
7. Autel TS401 TPMS Programming Tool.
Does AutoZone have TPMS tool?
Save Money by Monitoring Tire Pressure Whether you are simply getting started or in the market for new tools, AutoZone has a diverse inventory of the best tire pressure monitoring system tools for cars and trucks on the market.
How do you reset the tire pressure sensor on a 2010 Chevy Equinox?
How much does it cost to replace the tire pressure sensor?
The service kit costs $5-$10 per wheel on most vehicles. A special TPMS tool and additional time are also needed to check and reset the sensor system. In the event pressure sensors need to be replaced, the cost ranges from $50-$250 each depending on vehicle type.
What does it mean when your car says Service Tire Monitor System?
Whenever your car says service tire monitor system, this means that more than likely you have a bad tire pressure monitor sensor (TPMS). … This warning is just letting you know something is wrong with the TPMS. A TPMS or service tire monitor system, just lets you know when your tire pressure is too low or too high.
Can I reset the TPMS by disconnecting the battery?
Disconnect and Reconnect the Car’s Battery Your car has an onboard computer that checks all the sensors in the vehicle (including the tire pressure sensors) and decides what to do with that information. … A quick and easy way to reset your computer is to disconnect and reconnect your car’s battery.9 avr. 2020
How do I use the TPMS reset tool?
【 Easy to use 】TPMS reset tool can help you reset all tires much easier just with 3 steps. Ensure that the vehicle is in the TPMS Learn Mode, and follow the service procedure. Hold tool against the sidewall of the tire, near the valve stem. Depress Learn button while holding the tool against the tire sidewall.