1. Turn the ignition key to the “ON” position without starting the engine.
2. Press the Remote Keyless Entry (RKE) transmitter’s LOCK and UNLOCK buttons simultaneously for five seconds.
3. Activate the TPMS sensor.
Contents
How do you reset the TPMS on a 2018?
1. Press MENU.
2. Select Customize Settings.
3. Select TPMS Calibration.
4. Select Initialize.
5. Select Yes.
6. Press MENU to exit.
steering wheel
Why is my tire pressure light on when my tires are fine?
TPMS Light stays on all the time This could either mean air pressure in one or more of your tires is low. If you have already checked and know that this isn’t the case, then it could indicate that the TPMS sensor is not reading correctly.10 mar. 2021
How do I reset the Service tire Monitor System?
With the vehicle off, turn the key to the “on” position, but don’t start the car. Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and wait 20 minutes for the sensor to refresh. The TPMS reset button is usually located beneath the steering wheel.
What should the tire pressure be on a 2018 Chevy Equinox?
Recommended tire pressure for 2018 Chevrolet Equinox is 35 psi for front tires and 35 psi for rear tires.
How do I reset my oil life on my 2019 Equinox?
What is the tire pressure for a 2018 Equinox?
The tire pressure for the Equinox iS35 psi for both the front and rear tire for all versions. The size of the wheels are 17 to 19 inches in diameter and 7 to 7.5 inches in width.
How do I get the TPMS light to go off?
Drive the car at 50 mph for about 10 minutes. This should reset the sensor, and the next time you start the car the TPMS light should be off. Without starting the car, turn the key to the “On” position. Press the TPMS reset button and hold it until the light blinks three times, then release it.
How do you calibrate a tire pressure sensor?
1. Monitors the tire pressure while you are driving.
2. Press and hold the TPMS button until the low tire pressure indicator blinks twice, indicating the calibration process has begun.
3. Use the steering wheel buttons to make and enter selections in the Driver Information Interface (see page 29).
How do you know if you have a bad TPMS sensor?
TPMS warning light A small light illuminates at the dashboard’s display panel whenever there is a problem with the tire pressure sensors. It appears as a vivid yellow exclamation point inside of a U symbol; you’d be easily able to spot it. As soon as it turns on, the driver must check the tire for less or no air.
Can I reset the TPMS by disconnecting the battery?
Disconnect and Reconnect the Car’s Battery Your car has an onboard computer that checks all the sensors in the vehicle (including the tire pressure sensors) and decides what to do with that information. … A quick and easy way to reset your computer is to disconnect and reconnect your car’s battery.9 avr. 2020
Why is my TPMS not working?
TPMS problems can include any of the following: … The TPMS module itself is not functioning properly or has failed because of a voltage supply, wiring or internal electronics fault. • The tires were serviced or rotated recently and the relearn procedure was not done correctly.
How do I use the TPMS reset tool?
【 Easy to use 】TPMS reset tool can help you reset all tires much easier just with 3 steps. Ensure that the vehicle is in the TPMS Learn Mode, and follow the service procedure. Hold tool against the sidewall of the tire, near the valve stem. Depress Learn button while holding the tool against the tire sidewall.