Attach the red jumper cables first. Start by clamping one red cable to the positive side of the battery that won’t start. Then attach the other red clamp to the positive side of the working battery. Next, clamp one black cable to the negative side of the working battery.
Contents
How do you jump a 2016 Chevy Equinox?
Where do you connect jump start?
1. Take out your jumper cables.
2. Place both vehicles in Park or Neutral and shut off the ignition in both cars.
3. Attach one of the red clips to the positive terminal of your battery.
4. Attach the other red clip to the positive terminal of the other car.
How do you jump a 2017 Chevy Equinox?
Why shouldn’t you connect the negative terminal?
Why can’t you connect the black jumper cable to the dead battery’s negative (–) terminal? … This is so you can avoid sparks from occurring near the battery where flammable hydrogen gas may be present, resulting in a possible explosion.
Why do you connect the positive terminal first?
Connect positive first, negative having less potential won’t arc. The higher the voltage, the greater the chance of arcing and fusion. On a car if negative first and you are touching any metal part of car, when attaching positive there is possibility of arcing through you. Your body becomes part of the circuit.
Where is the negative on a Chevy Equinox battery?
The remote positive (+) terminal (1) is located on the underhood fuse block, on the driver side. Lift the red cap to uncover the terminal. The remote negative (−) terminal (2) is a stud behind the metal tab stamped with GND (−) near the driver side strut tower.
How long should Jumping a car take?
Allow it to run for 1-2 minutes. Rev the engine slightly by pressing on the gas pedal lightly. Start the engine of the dead car. It may take more than one try, but do not try to restart it more than three or four times.
Is red positive or negative?
One is marked positive (+), the other negative (-). There are also positive and negative cables in the jumper cable set. The red one is positive (+), the black one is negative (-). Never connect the red cable to the negative battery terminal or a vehicle with a dead battery.
Which battery terminal do you connect first when jumping?
positive cables
Which battery terminal do you connect first?
“Positive first, then negative. When disconnecting the cables from the old battery, disconnect the negative first, then the positive. Connect the new battery in the reverse order, positive then negative.”
Can you call someone to jump your car?
If your vehicle is stranded and you’re in an emergency situation where you believe your safety is at risk then yes, you can definitely call the police to help jump-start your car. This also applies if you’re in a dangerous, unlit area. Police are trained to help stranded motorists.20 août 2020
How can I boost my equinox?
Connect one end of the positive jumper cable to the positive terminal on the battery of the car that is providing the jump. Connect the other end of the positive jumper cable to the positive terminal on your Equinox.