1. Turn the ignition key to the “ON” position without starting the engine.
2. Press the MENU button on the turn signal lever briefly until you see the OIL LIFE menu on the display.
3. Scroll down to the “TIRE PRESSURE” menu.
4. Press and hold the SET/CLR button until the horn sounds twice.
Contents
What is the tire pressure for a 2016 Chevy Trax?
Recommended tire pressure for 2016 Chevrolet Trax is 35 psi for front tires and 35 psi for rear tires.
How do you reset the TPMS on a 2016 Chevy Trax?
To reset the TPMS light all You need to do is put the vehicle in the on position and then press and hold the reset button that is located on the dash to the right of the steering wheel. After that You will need to drive for about ten minutes to let the sensors full reset.
How do you check tire pressure?
What is the best TPMS relearn tool?
1. VXDAS EL-50448 TPMS Tool for GM – Editor’s Pick.
2. JDIAG 2IN1 EL50448 TPMS Relearn Tool for GM and Ford.
3. Autel MaxiTPMS TS501 TPMS Programming Tool.
4. VXSCAN El-50448 Auto TPMS Reset Tool.
5. ATEQ VT31 TPMS Reset Activation Programmer Tool.
6. Autel TS408 Handheld TPMS Service Tool.
7. Autel TS401 TPMS Programming Tool.
What is a TPMS relearn tool?
VXDAS TPMS Relearn Reset Activation Tool for GM series Vehicles (Chevy / Buick / GMC / Opel / Cadillac etc, from 2006-2021, Cars, SUV, Pickup), equipped with Tire Pressure Monitor system (TPMS) sensor.It can quickly reset tire sensors after you do tire rotation or change a new tire.
How do you reset the tire sensor on a Chevy Trax?
How do you reset the trip on a 2020 Chevy Trax?
Hold the right button on your dashboard for several seconds until zero is shown on the trip odometer. If this button does not operate, you can use the right-hand counter comodo by pressing the button at its end for a few seconds until the odometer of your Chevrolet Trax is reset to zero.25 fév. 2020
How do you reset the change oil light on a Holden Trax?
What the lowest tire pressure you can drive on?
20 pounds per square inch
Is 40 PSI good tire pressure?
Normal tire pressure is usually between 32~40 psi(pounds per square inch) when they are cold. So make sure you check your tire pressure after a long stay and usually, you can do it in the early morning.1 déc. 2020
Does tire pressure go up after driving?
As you drive, the rolling friction of the road increases heat in the tires, heat warms the air in the tire and the air expands, increasing the pressure. Manufactures recommend a max psi COLD. They know that the pressure will rise after driving.
Can I program my own TPMS?
Yes, you do. After you must have programmed the TPMS sensors, you will need to write a new TMPS sensor ID to the vehicle’s ECU. This process is known as a “relearn procedure” and can only be executed with a TPMS relearn tool.
How much does it cost to reprogram a tire pressure sensor?
The average cost for tire pressure monitoring system relearn is between $35 and $44. Labor costs are estimated between $35 and $44. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.