Beside above, what oil does a 2004 Ford Explorer use? Ford Explorer 4.0L 2004, Extended Performance™ SAE 5W-30 Full Synthetic Motor Oil, by Mobil 1®.
Considering this, how much oil does a 2004 Ford Explorer take? Capacity: 5 quarts. (with filter)When refilling, remove dipstick to provide adequate venting and allow oil to flow into crankcase. After refill, check oil level.
In this regard, how do you change the oil on a 2005 Ford Explorer?
Likewise, how many quarts of oil does it take to change? Typically, you’ll use 4 to 5 quarts of oil, but check your manual for your car’s oil capacity. Fill to three-quarters of the engine’s capacity to avoid overfilling, as there is always oil that does not drain.
Contents
Where is the oil stick on a 2004 Ford Explorer?
Pop the hood to Your engine using the hood-release lever under Your dash panel near the steering wheel. You can then locate the transmission dipstick in the engine. Pull that straight up and wipe it off with a rag. Stick it back in the tube and pull it out again.
How do you reset the oil change light on a 2004 Ford Explorer?
What type of oil does a 2005 Ford Explorer use?
Of the three (3) engine options available on the 2005 Ford Explorer, both 4.0L V6 engines require 5W-30; while the 4.6L V8 requires 5W-20. All require the oil to be full synthetic oil.
Does Ford recommend synthetic oil?
Help keep the engine in your Ford or Lincoln vehicle running at its best with a synthetic motor oil that comes recommended by Ford Motor Company. Synthetic oil is engineered to create more lubrication and better performance in the engine of your Ford or Lincoln vehicle.
How often does a Ford Explorer need an oil change?
Ford recommends getting your 2021 Ford Explorer oil & filter replenished every 3,000-5,000 miles for conventional oil. Synthetic oil frequently should be replenished every 7,500 – 10,000 miles.
Can 5W30 be used instead of 5W20?
Can You Use 5W-30 Instead of 5W-20? In theory, yes, you can switch from using 5W-20 to the 5W-30 because they have similar viscosity ratings. In fact, often, when you take your car to a mechanic for an oil change, they’ll put the 30 instead of the 20 because it’s thicker.
How do you reset the oil change light on a 2005 Ford Explorer?
- Press the SETUP button repeatedly until “Press Reset At Oil Change” message is displayed.
- Press and release the RESET button to display “Hold Reset To Confirm”
- Press and hold the RESET button to see “Oil Life Set To 100%”
How much oil does a 2005 Ford Explorer take?
Capacity: 6 quarts (with filter)When refilling, remove dipstick to provide adequate venting and allow oil to flow into crankcase.
How do I know how much oil to add?
Check the dipstick to determine how much oil you need to add. Usually, the difference between the bottom of the stick and the top is 1 quart, X Research source so you can use this to estimate how much oil you want to add. If it is halfway full, for example, you need to add half a quart of oil.
Is it cheaper to change my own oil?
On a cost basis, if you own one of the more popular mainstream vehicles and usually get two or three oil changes done annually, you’re likely to save less than $20 each on average between the costs of having this service done at an independent shop or oil change chain and doing it yourself.