- Switch the ignition over to the on position.
- Go to the SETTINGS menu.
- Scroll and select VEHICLE.
- Scroll down to OIL LIFE RESET.
- Press and hold the OK button.
- Shut the vehicle off and then start it back up and check the oil change light should be gone.
Likewise, how do you check the oil on a 2013 Ford Explorer?
People ask also, how do you reset the oil life on a 2013 Ford Explorer?
Subsequently, how do you check the oil on a Ford Explorer?
- Read Through Your Owner’s Manual.
- Find the Right Materials.
- Warm Your Engine.
- Open the Hood.
- Locate the Dipstick.
- Check the Level on the Dipstick.
In this regard, how do you check the oil life on a Ford?
- Using the information display controls on the steering wheel, scroll to ‘Settings’ and press the right arrow button.
- Scroll to ‘Vehicle’ and press the right arrow button.
- Scroll to ‘Oil Life‘ and press the right arrow button.
The power steering fluid reservoir on the 2013 explorer is found on or near the engine, look for a yellow or white reservoir with a black cap.
Contents
How do you read a Ford Fusion dipstick?
How do you reset the oil change light on a Ford Explorer?
Turn the ignition to the ON position. Do not start the engine. Press and release the “Select/Reset” stem button on the instrument panel to toggle the options until the “Hold Reset For Setup Menu” option appears. Press “Select/Reset” to toggle the options until the “Hold Reset if New Oil” option appears.
How do you reset the oil life on a 2021 Ford Explorer?
How do you reset the oil life on a 2011 Ford Explorer?
To reset the ford explorer oil life light, put the ignition into on without starting engine. Use the pad on the steering wheel to scroll through the settings. Go to settings, vehicle, oil life reset. Push and hold ok.
Can I just add oil to my car instead of getting an oil change?
If you just add oil to your car’s engine periodically, that’s far better than letting your car run out of oil, but you’re still going to create a lot of problems if that’s all you do. … If that’s the case, you’re likely keeping the same oil filter in the engine, too. So that’s never being replaced.
How accurate is the oil life indicator?
Oil Life Monitoring systems are (thankfully) pretty accurate! Studies have shown that when the same vehicle was subjected to both around-town driving and then highway driving, the warning light came on much later during the highway driving.
Can you reset oil life monitor?
Press the Trip/Reset button to cycle to “Setup Menu Hold Reset” message. 2. Press and hold Trip/Reset button for two seconds until “Reset for System Check” message appears. … Immediately press and hold button for two seconds until “Oil Life Set To 100%” is displayed.
What percentage oil life should I change it?
Make sure the monitor is reset every time the oil is changed and I would change it between 40 and 20 percent.
How do I reset my Ford oil change?
What is Ford oil life?
Your Ford’s Intelligent Oil-Life Monitor (IOLM) uses actual engine data and operating conditions plus your driving habits to calculate precisely when you need an oil change. In equipped vehicles, a dash message alerts you when it’s time to change the oil and filter.