If You would like to find out how much transmission fluid to use on Your 2004 Ford Explorer, then look no further. The transmission fluid capacity on Your Explorer is 12.7 quarts. If You also would like to know what type of transmission fluid to use then it is Motorcraft MERCON V ATF.
Also, how many quarts of transmission fluid do I need for a Ford Explorer? The 2001 Ford Explorer takes 14 quarts of transmission fluid.
Likewise, what type of transmission fluid does a 2004 Ford Explorer take? Ford Explorer USA Built 2004, Mercon V Automatic Transmission Fluid by Motorcraft®.
People ask also, how do you put transmission fluid in a 2004 Ford Explorer? Locate the intake spout on the transmission, then insert a funnel if needed. Pour fluid into the vehicle until the dipstick show that it is full. Put the dipstick back, close the intake spout and you are finished.
Also know, how much transmission fluid do I need to add? In general, transmissions take about 9 to 13 quarts to fill completely. The amount of transmission you add will vary, depending on whether you are draining or replacing it all or you are just topping it up. Again, you should avoid adding too much. It is advisable to put in little amounts at a time.Capacity: 5 quarts. (with filter)When refilling, remove dipstick to provide adequate venting and allow oil to flow into crankcase. After refill, check oil level.
Contents
How do you add fluid to a sealed transmission?
How do you change a transmission filter on a 2004 Ford Explorer?
Where is the transmission fluid dipstick on a 2004 Ford Explorer?
Pop the hood to Your engine using the hood-release lever under Your dash panel near the steering wheel. You can then locate the transmission dipstick in the engine. Pull that straight up and wipe it off with a rag. Stick it back in the tube and pull it out again.
How do you fill a Ford Explorer transmission?
What are the symptoms of low transmission fluid?
- Warning light.
- Transmission overheating.
- Difficulty in shifting gears.
- Transmission fluid leakage.
- Generation of unusual sounds.
- Transmission slipping problems.
How often should you change transmission fluid Ford Explorer?
Every 150,000 miles, the automatic transmission fluid should be changed, and the accessory drive belts will be replaced if they haven’t been changed out in the last 100,000 miles.
How do you check transmission fluid without dipstick?
What happens if you drive with low transmission fluid?
Low-quality transmission fluid – or driving without transmission fluid altogether – can cause a number of problems such as transmission failure, gear slipping, a hard time shifting, and a few more issues.
What happens if you add too much transmission fluid?
Transmission Fluid Leakage: Adding too much fluid will cause high pressure inside of your transmission. This is very bad and could cause your transmission to start leaking fluid everywhere. This would damage other parts of the system. … These gears will have a difficult time-shifting making it more difficult to drive.
Can I just add transmission fluid?
Pull out the transmission fluid dipstick. Usually, you should not have to add transmission fluid. If the level is down significantly below the “Add” or “Cold” line, you probably have a system leak and should take the car to your mechanic to have your car inspected for leaks by a technician.