Ford Explorer

How to change water pump on 2013 ford explorer?

The average cost for a Ford Explorer water pump replacement is between $546 and $730. Labor costs are estimated between $436 and $551 while parts are priced between $109 and $180.

Amazingly, where is the water pump located on 2013 Ford Explorer?

Beside above, how much does it cost to replace a water pump in a 2013 Ford Edge? How much does a water pump replacement cost for the 2013 ford edge? The average cost for a 2013 Ford Edge water pump replacement is between $940 and $1,180. Labor costs are estimated between $800 and $1,020 while parts are priced between $130 and $160.

Additionally, how many labor hours does it take to replace a water pump? Expect to pay $200-$450 total for labor, depending on the how difficult it is to reach the water pump, any additional parts that need to be removed and whether the car uses a timing belt or timing chain. The job takes about three and a half to four hours to complete.

People ask also, can I drive with bad water pump? The car may begin to overheat as well. It is possible to drive your vehicle without a water pump, but not good to. Some people in the racing circuit or who drive racing vehicles purposefully remove their water pumps to obtain more horsepower to their engine.

Contents

How long do ford water pumps last?

Water pumps are designed to last at least 100,000 miles, however, if your water pump fails, you should replace it with a high-quality original-equipment level unit. Less expensive replacement pumps are available, but they might only have a service life of 30,000 miles.

Did Ford fix the water pump issue?

Ford fixed the owner manuals to have the water pump checked after so many miles. After these issues occurred to many, Ford stopped building the water pumps inside the engine. There were no recalls, but class-action lawsuits made them fix the problem.

What cars have internal water pumps?

  1. Ford Edge 2007–2010.
  2. Ford Edge 2015–Present.
  3. Ford Edge 285 2011–2014.
  4. Ford Explorer 2011–Present.
  5. Ford F-150 282 2015–2017.
  6. Ford Flex 2009–Present.
  7. Ford Fusion Sport 2010–2012.
  8. Ford Taurus 2008–Present.

How much is a water pump for a Ford Explorer?

Ford Explorer Water Pump Replacement Cost Estimate. Labor costs are estimated between $512 and $646 while parts are priced between $154 and $195. This range is based on the number and age of Ford Explorer’s on the road.

How much does it cost to replace a water pump in a 2013 Ford Taurus?

The water pump is very important because it is what circulates the coolant through Your engine and back to the radiator so it needs to be replaced about every 100,000 miles. This costs about $250 for the part and you are looking at about $400 for the labor. So total of about $650 – $750 to do this job.

How much does water pump cost to replace?

The average water pump replacement cost is $550, with prices ranging from $461 to $638 in the US in 2020. But typically depends on the type of vehicle you drive and the auto repair shop you take it to. Labor costs are between $256 and $324 while parts cost between $205 and $314.

Where is the water pump located on a 2013 Ford Fusion?

What are the signs of a bad water pump?

  1. Overheating. A dead or dying water pump cannot circulate coolant through your vehicle’s engine and, as such, the engine will overheat.
  2. Coolant Leaks. Coolant leaks from the water pump are common and a clear sign that it’s time to replace the pump.
  3. Corroded Water Pump.
  4. Whining Noises.

Is it hard to replace a water pump?

While removing the pump is not difficult, you must have experience removing and replacing timing belts and their various components. It takes just as much work to get down to the timing belt as it does the water pump, therefore you should plan on replacing the belt at the same time.

What causes a water pump to go bad?

The most common water-pump failure is due to worn bearings. Water pumps move a tremendous amount of coolant, and they just simply wear out over time. … And mixing coolants, or using the wrong coolant, can cause damage to the water-pump seals and bearings, and can lead to the impeller shaft to fail.

See also:   How to clean ford throttle body?
Back to top button

Adblock Detected

Please disable your ad blocker to be able to see the content of the page. For an independent site with free content, it is literally a matter of life and death to have ads. Thank you for your understanding!