If the check engine light in your Ford Explorer starts flashing, that means that the problem needs immediate attention and your Ford should be brought in abruptly. … This blinking light usually indicates a draconian engine misfire allowing unburned fuel to be dumped into the exhaust system.
Correspondingly, why is the check engine light on in my 2013 Ford Explorer? 2013 Ford Explorer Check Engine Light Flashing Assorted pure reasons for a Check Engine Light are dirty mass airflow sensor, faulty head gasket, damaged oxygen sensor, a malfunction with the fuel injection system, faulty emissions control part, or defective spark plugs to name a lot.
In this regard, how do you reset the check engine light on a 2013 Ford Explorer? Insert the key into the ignition to do this, turn the car on for about a second, then off for about a second. Do this two times more then drive the car as normal. This can be done by putting the car on and back off three times in quick succession.
People ask also, how do I run a check engine light diagnostic?
Similarly, what is the most common reason for check engine light? Replacing a faulty oxygen sensor — a sensor used to optimize a vehicle’s fuel-to-air mixture to increase gas mileage and reduce emissions — is the most common cause for a check engine light.
Contents
How long can you drive with check engine light on?
When the check engine light is solid, you can typically drive the car for hundreds of miles without an issue. Of course, that depends on which code is stored in the vehicle’s computer. If an engine sensor is faulty, the car will usually use made up sensor values to keep running.
How many O2 sensors does a 2013 Ford Explorer have?
On a Ford 3.0 V6, there are a total of (4) O2 sensors, two on each side of the engine. There are upstream and downstream sensors, two of them on the exhaust manifold are upstream, and two after the catalytic converter that are downstream.
Where is the O2 sensor on a 2013 Ford Explorer?
The 2013 Ford Explorer oxygen sensor is located on the exhaust at the catalytic converter.
How many catalytic converters are in a 2013 Ford Explorer?
Your explorer certainly has 3 converters, they are available in the y assembly for around $600.
Will check engine light reset itself?
Your vehicle’s check engine light will will reset by itself once the issue or problem has been repaired; this is true for most models. … If you are certain that you have resolved the issue that caused your check engine light to come on in the first place, then the light should reset itself after at least 20 cycles.
How do I turn my check engine light off?
How do I permanently turn off my check engine light?
Does AutoZone do free diagnostic?
At AutoZone, you don’t need to pay for testing your car. You can get your car’s parts tested for free at AutoZone. We can check out your car’s battery, alternator, starter, and voltage regulators while they’re still on your car.
Where can I get my check engine light checked for free?
- Advance Auto Parts.
- AutoZone.
- Napa Auto Parts.
- O’Reilly Auto Parts.
- Pep Boys Auto Parts.
Why is my check engine light flashing?
A flashing CEL indicates a severe problem, one that requires immediate car repair. In other words, if your check engine light is flashing, pull over and call a tow service. … Ultimately, an engine misfire is the most common cause of a flashing CEL.