There is not an official way to disable the door ajar alarm on the Ford Explorer. What You can do is open the dash board of the car, and locate the module that controls it and pull it out. If this sounds like to much work You can also find the fuse that powers it and then pull it.
Likewise, how do you remove the ajar switch on a 2002 Ford Explorer?
- Remove the plastic cover around the door handle.
- Lift up the door switch panel from the front and remove.
- Remove three screws holding the door panel in place.
- Lift the panel enough to reach the electrical connector to the outside mirror switch.
People ask also, how do you disable a car door sensor?
Also, how do you fix a door ajar light on a 2003 ford Expedition?
Also know, how do you remove a door ajar light? Spray the WD-40 liberally, and open and close each door firmly a dozen times, to work the lubricant into the mechanisms. Apply more WD-40 and repeat. If the WD-40 fix does not turn off the light, we recommend having a mechanic take a look.To reset the alarm on the Ford Explorer You have two options. You can pop the hood and disconnect the positive battery cable, then leave it off for about 30 minutes. This will make the power in the CPU drain, which will force the system to reset itself the next time it comes on.
Contents
How do you turn the interior lights off in a Ford Explorer?
By default, interior lights illuminates when you open the door on Ford Explorer. You can’t turn them off, there is no button or switch to turn them off.
How much does it cost to fix door ajar sensor?
How much does it cost to fix a car door sensor? According to the national average, new sensor replacement can start at anywhere from $150 – $200. With Puls, garage door cable replacement or repair starts at just $90.
How do you fix a bad door sensor?
How do you fix a door sensor?
- Remove the old sensor. Use a screwdriver to disconnect the wires from the old sensor.
- Connect the new sensor. Use a screwdriver to connect the existing wires to the new door sensor.
- Mount the new sensor. Apply the new sensor to the door frame.
- Test the new sensor.
Where is the ajar fuse on a 2003 expedition?
The 2003 Ford Expedition will have two fuse boxes in the vehicle. The first is going to be under the hood and near the battery. This one is not going to contain the door ajar fuse. The one You will want is the second fuse boxAnd it’s going to be under the dashboard.
How do you change a ajar switch on a 2003 Ford Expedition?
How do you test a door ajar switch?
Why does dome light stay on?
What does it mean when a door is ajar?
: slightly open left the door ajar.
How do you fix a dome light that stays on?
- Adjust the dome light switch. Every vehicle has one.
- Open each door and locate the door switch.
- Start the vehicle and allow it to run for five minutes.
- Trace the wiring for each switch.
- Remove the bulb to avoid draining the battery until the wiring can be inspected by a mechanic.