How to reset a 1999 ford explorer?

Likewise, how do you reset the computer on a 99 Ford Explorer?

1. Open the hood: release the primary latch by pulling the release lever under the steering wheel near the floor board.
2. Disconnect the negative battery terminal.
3. Wrap the negative clamp in a towel.
4. Leave the negative battery cable off for a minimum of five minutes.

Also, how do you reset the computer on a Ford Explorer?

1. Open the hood of the Ford. Loosen the lock nut located on the negative battery cable connector with a socket and ratchet.
2. Wait for 20 minutes while the PCM bleeds off the electricity it stores for backup power. Once the power drains from the PCM, it resets.

Also know, where is the reset button on a Ford Explorer? To reset the fuel light on a ford explorer you will need to access the fuel reset switch which is located in the glove box or in the foot well of the passenger seat area, press that switch and the fuel system will be reset.

People ask also, how do you reset the door code on a 1999 Ford Explorer?

1. Find your Explorer’s master-keypad code.
2. Type the master code on the keypad.
3. Press the “7/8” and “9/0” simultaneously, within five seconds of pressing “1/2.” This erases the custom code.
4. Enter the master code to begin programming your custom code.

How do you reprogram a powertrain control module?

To reprogram a PCM or other vehicle module, you need a factory scan tool, or an aftermarket scan tool with reprogramming capabilities, or a J-2534 compliant “PassThru” interface tool (or J-2534-1 for 2004 & newer vehicles) that can connect a PC or scan tool to the vehicle’s diagnostic connector or module.

Will disconnecting the battery reset the computer?

While disconnecting the battery will not permanently damage your vehicle’s computer, it can cause it to function differently. That’s because, if you disconnect your battery for long enough to reset the computer, it may cause the processor to forget everything it has learned.

How do you reset the computer on a Ford Taurus?

To reset the computer on the car then You have two options. You can pull the battery cable and let it sit for about 30 minutes. If You don’t want to do that then You can pull the fuse and do the same. To get to the fuse box look to the left of the steering wheel look for a small seam or crack along the dash.

How do you reset a transmission control module?

1. Step 1: Turning Key Position.
2. Step 2: Press gas pedal.
3. Step 3: Keep Waiting.
4. Step 4: Turning the Key Off.
5. Step 5: Releasing Gas Pedal.
6. Step 6: Wait Again.
7. Step 7: Ready.
8. Identification.

Where is the reset button on a 97 Ford Explorer?

The reset switch is on the passenger kick panel under the carpet.

What does a fuel reset button do?

In the event of an accident, the “Fuel Reset Button” will turn off the fuel pump and system.

How do I reset my 2008 Ford Explorer?

How do you reset the door code on a 1998 Ford Explorer?

1. Use the keypad to enter the factory set code.
2. Within five seconds, press the 7/8 and 9/0 buttons simultaneously.
3. The system will now respond only to the factory set code.

How do you unlock a locked key in a Ford Explorer?

Hold one end of the string in each hand, slide it through the corner of the car door, and use a back-and-forth motion to get it down far enough so that the knot can slide over the doorknob. Once it’s in place, pull on the string to tighten it and pull up to unlock it.

How do I reset my Ford door code without factory code?

If You need to reset Your keyless entry code in Your Ford Edge but do not have the original code the only way to do it is to contact a Ford dealership. You will need to bring Your vehicle in to them and allow them to connect diagnostic software to it in order to read the code that is stored in the ECU.