- Turn the ignition to the off position.
- Check the fuel system for leaks.
- If no leaks are apparent, reset the switch by pushing in on the reset button.
- Turn the ignition to the on position.
- Wait a few seconds and return the key to the off position.
- Make another check for leaks.
Likewise, how do you reset a fuel pump switch?
- Locate your car’s inertial trigger or airbag control module.
- Push the button on the inertial switch; it should be clearly marked as the fuel pump reset, and may be in a contrasting color to the case.
Also, where is the fuel reset switch? Look for the fuel pump switch or inertia switch. This is a small box with a plastic button on top and an electrical connector at the bottom. On some vehicle models, this will be located in the luggage compartment. Look on a side panel for a small, round button which you can pry off with a small screwdriver.
Also know, how do you bypass a fuel pump shut off switch?
People ask also, how do you reset the fuel pump switch on a 1999 Ford Explorer?
- Turn the ignition to the OFF position.
- Check the fuel system for leaks.
- If no fuel leak is apparent, reset the fuel pump shut-off switch by. pushing in the reset button.
- Turn the ignition to the ON position. Pause for a few seconds and.
- Make a further check for leaks in the fuel system.
If the fuel pump is not coming on, and the fuse and relay are good, then it may be possible that there is a problem with the pump or the fuel pump circuit. … If it is not then there may be some sort of wiring issue before the fuel pump relay, perhaps a wiring issue or other problem with the ignition switch.
What would make my fuel pump not work?
These include a bad fuel pump relay or control module, a blown fuse, a wiring fault, loose or corroded wiring connector at the pump, or even an issue with the anti-theft system. Until these other possibilities have been checked out and eliminated, the fuel pump should be the last thing that’s replaced.
How do I reset my Ford fuel switch?
The switch is designed to trip and cut power to the fuel pump in the event of a collision, but you can also trigger it by hitting a large bump or pothole as well. To reset your Ford’s inertia switch, press down on the reset button.
In the event of an accident, the “Fuel Reset Button” will turn off the fuel pump and system.
How do I know if my inertia switch is bad?
- Engine suddenly stops while driving.
- Switch that trips for no reason.
- No start condition.
How do you test a fuel pump control module?
Is inertia switch supposed to be up or down?
The inertia switch is a safety item incorporated by Ford in the fuel system of its vehicles. The only time the inertia switch should trip is during a collision. On the top of the inertia switch is a red button. With the inertia switch in the open position, the red button is raised up.
What are the symptoms of a bad fuel pump driver module?
Symptoms of a failing fuel-pump driver module all manifest in the performance of the engine. Difficulty in starting or a smoky start-up, stalling or uneven running while idling, hesitations and misses when driving, and power surges when in reverse can all — separately or together — be indicative of a failing module.
How do you reset the fuel pump on a 2000 Ford Explorer?
It’s in the passenger side footwell, up about 8″ from the floor. The button should be just above the top of the plastic kick panel.
Where is the fuel pump reset switch on a Ford f150?
Reset the fuel pump cut-off switch by pressing the small, round button, located near the passenger-side kick panel, underneath the right-side portion of the glove compartment.
Where is the inertia?
The inertia switch is located behind the trim on the left-hand side of the vehicle, forward of the front door post, below the fascia. A finger access hole in the trim allows the driver to reset the switch.