- Locate the “TRIP/RESET” button on your vehicle’s control switch. Press and hold the “TRIP/RESET” button to select the “SYSTEM CHECK” option.
- Depress the “TRIP/RESET” button then select “OIL LIFE RESET.” The message display will show “HOLD RESET IF NEW OIL.”
Likewise, how do I reset my 2006 Ford Explorer?
People ask also, how do you reset the oil change light on a Ford Explorer? Turn the ignition to the ON position. Do not start the engine. Press and release the “Select/Reset” stem button on the instrument panel to toggle the options until the “Hold Reset For Setup Menu” option appears. Press “Select/Reset” to toggle the options until the “Hold Reset if New Oil” option appears.
Also, how do you reset the oil change light on a 2005 Ford Explorer?
Also know, how do you reset the oil life on a 2007 Ford Explorer?
The 2006 Ford Explorer wrench indicator light means you have a concern in the fly by wire throttle actuation. You no longer have a cable, but a computer controls the throttle for speed opening or a trans concern. The most common problem is the throttle position sensor on the throttle body is bad.Contents
What type of oil does a 2006 Ford Explorer use?
Ford Explorer 4.0L 2006, SAE 5W-30 Synthetic Blend Motor Oil, by Motorcraft®. This product is made of high-quality components to meet and exceed strict quality requirements.
How do I reset my oil change light?
How do you reset the oil change light on a Ford app?
How do you reset the oil change light on a 2011 Ford Explorer?
What does service engine soon light mean on a 2005 Ford Explorer?
When filling up at any gas station, shut the car off. The fuel/ evap system is typically a sealed system when the truck is running. When you are re-fueling, the “seal” is broken and over a period of time this can set the CEL light or service engine soon light.
How do I reset my Ford Explorer?
- Open the hood: release the primary latch by pulling the release lever under the steering wheel near the floor board.
- Disconnect the negative battery terminal.
- Wrap the negative clamp in a towel.
- Leave the negative battery cable off for a minimum of five minutes.
How do you reset the service light on a 2003 Ford Explorer?
What does the wrench light mean on a 2007 Ford Explorer?
The wrench light on a 2007 Ford Explorer means that it is time for a service on the vehicle. Usually it will be something simple like an oil change, but could be more involved like a transmission fluid change. It is impertinent to always keep up on the maintenance with Your vehicle.
What kind of oil does a 2007 Ford Explorer take?
The 4.0L V6 SOHC engine for the 2007 Ford Explorer needs 5 quarts of 5W30 synthetic oil while the 4.6L V8 engine option takes 6.3 quarts of 5W20 synthetic oil.
How much oil does a 2007 Ford Explorer take?
Capacity: 5 quarts (with filter)When refilling, remove dipstick to provide adequate venting and allow oil to flow into crankcase.