The wrench light on a 2007 Ford Explorer means that it is time for a service on the vehicle. Usually it will be something simple like an oil change, but could be more involved like a transmission fluid change. It is impertinent to always keep up on the maintenance with Your vehicle.
People ask also, how do you reset the maintenance required light on a 2007 Ford Explorer?
Also know, how do you reset the wrench light on a 2006 Ford Explorer? The wrench light on the 2006 Ford explore is the check engine light. There is no way to reset the check engine light on the vehicle. It comes on when there is something wrong with the car, but it can be caused by just about anything.
Also, how do I reset my Ford wrench light? Switch the ignition on, but do not start the vehicle’s engine. Press the accelerator and the brake pedals at the same time and hold them down for 30 seconds. After 30 seconds have passed, you will see the wrench light indicator disappear.
Likewise, can you drive with wrench light on? It is suggested that you have your car towed into a mechanic’s garage, or, if you are one of the lucky few who still have your car on and able to drive, you drive your vehicle to a garage immediately. It is unsafe to drive with this light on for long as it may stall and won’t come back on at any given moment.
Contents
What does the wrench symbol mean on a Ford?
The wrench warning light on Ford vehicles is the powertrain malfunction indicator light. When it illuminates, it means that the computer has detected an issue with your vehicle’s powertrain or four-wheel-drive system.
How do I reset my 2007 Ford Explorer?
How do I reset my Ford Explorer?
- Open the hood: release the primary latch by pulling the release lever under the steering wheel near the floor board.
- Disconnect the negative battery terminal.
- Wrap the negative clamp in a towel.
- Leave the negative battery cable off for a minimum of five minutes.
How much oil does a 2007 Ford Explorer take?
Capacity: 5 quarts (with filter)When refilling, remove dipstick to provide adequate venting and allow oil to flow into crankcase.
What does a wrench light mean on Ford Explorer?
The wrench light on a Ford Explorer is the powertrain malfunction indicator. When the vehicle computer detects a problem with the engine or transmission, it turns on the wrench light and restricts the vehicle’s performance. When it comes on, You may experience a severe reduction in the vehicles performance.
Why does my 2007 Ford Fusion have a wrench light?
The appearance of this light indicates that the power train has suffered a malfunction. … The wrench light on a ford fusion dash simply means it is similar to the check engine light, and this means that the car’s on-board computer has stored a fault code. So, basically, the wrench light works as a check engine light.
How do you get a wrench light off?
Why does the wrench light come on?
The wrench light is a powertrain malfunction indicator light. When it comes on, you may experience a severe reduction in the vehicle’s performance. The causes of the problem lie on throttle control and/or transmission. The light may come on along with the check engine light.
What does a wrench indicator light mean?
When the wrench light illuminates, it is letting you know it is time to make an appointment for your next service. This mostly serves as a warning or a reminder to make the appointment now.
What is a powertrain fault?
What is Powertrain Fault? Having a powertrain failure or powertrain fault tends to happen to older and or higher mileage vehicles and can cause your vehicle’s power components to overheat. If you ignore these warnings, your vehicle may operate in a defaulted “safe mode” until the issue has been resolved/repaired.