To reset it, go ahead and turn Your ignition to the ON position but do not start the engine. Now, on Your cluster, press the Select button and head to Set Up Menu Hold Reset. Hold the Select button for around 3 seconds and then let it go. Press the Select button again until You get to Hold Reset If New Oil.
Likewise, how do you reset the oil change light on a Ford Explorer? Turn the ignition to the ON position. Do not start the engine. Press and release the “Select/Reset” stem button on the instrument panel to toggle the options until the “Hold Reset For Setup Menu” option appears. Press “Select/Reset” to toggle the options until the “Hold Reset if New Oil” option appears.
People ask also, how do you reset the oil change light on a 2010 Ford Explorer?
- Get in the car and turn key to the on position.
- Go to the SETUP MENU HOLD RESET screen.
- Press and hold the SELECT/RESET button.
- Enter to the RESET FOR SYSTEM CHECK menu.
- Scroll to OIL LIFE.
- Hold down the SELECT/RESET button.
Also know, how do you reset the oil light on a 2016 Ford Explorer?
Also, how do you reset the oil change light on a 2013 Ford Explorer?
The light could be on after an oil change because of an issue with the oil pump. If this is the cause, there could be not enough oil circulating through to the various parts. Performing regular oil changes should help prevent this from happening, but parts do wear out.How do I reset my oil change light?
What does the wrench light mean on a 2010 Ford Explorer?
If You see the wrench light turn on in the dash of Your 2010 Ford Explorer this means that Your ECU has detected a fault. I recommend getting off the road as soon as possible because continuing to drive can cause more damage to Your SUV.
How do you reset the oil life on a 2011 Ford Explorer?
- Switch the ignition over to the on position.
- Go to the SETTINGS menu.
- Scroll and select VEHICLE.
- Scroll down to OIL LIFE RESET.
- Press and hold the OK button.
- Shut the vehicle off and then start it back up and check the oil change light should be gone.
How do I reset my Ford Explorer?
- Open the hood: release the primary latch by pulling the release lever under the steering wheel near the floor board.
- Disconnect the negative battery terminal.
- Wrap the negative clamp in a towel.
- Leave the negative battery cable off for a minimum of five minutes.
How do you reset the oil light on a 17 Explorer?
Using the information display controls on the steering wheel, scroll to ‘Settings’ and press the right arrow button. Scroll to ‘Vehicle’ and press the right arrow button. Scroll to ‘Oil Life’ and press the right arrow button. Press and hold the OK button until a ‘Reset Successful’ message appears.
How do you reset the oil light on a 2017 Ford Explorer?
How do you reset the oil light on a 2012 Ford Explorer?
To reset the oil level warning or maintenance light in your 2012 ford explorer vehicle, turn the ignition key to the “on” position and depress the gas pedal slowly three times. Release and start your vehicle and oil light should indicate a reset.
How do you reset the computer on a 2014 Ford Explorer?
To reset the 2014 ford explorer check engine light, insert the key into the ignition, turn the vehicle on for a second, then off for another second, then repeat two more times.
Why is my oil light on but my oil is full?
When the oil light on your dashboard comes on, it might mean your vehicle has low oil pressure. This drop in oil pressure could be a sign of a few things: you are low on oil, your oil is dirty, or you have an oil leak.
Why does my oil light keep going on and off?
If the oil light flickers on and off while the vehicle is stopped or at an idle, there may be a problem with the oil sensor or the pressure is too low. … Check the oil level and add motor oil to the vehicle, if needed, and continue to monitor the light. If the oil was indeed low, the light should turn off.