First, go to the driver’s side of Your vehicle, and insert the key into the lock. Turn the lock to the right, or to the unlock position. Hold this position and count for 25 to 40 seconds. Doing this will bypass the anti-theft system.
Likewise, how do you turn off the anti-theft system on a 2002 Ford Explorer? The 2002 ford explorer anti theft can be reset by unlocking the car with the key, and putting the ignition on.
Also, how do I get my Ford out of anti theft mode?
- Turn off the ignition and check your doors – all of them have to be closed.
- Insert the key in the ignition and turn it to “On”.
- Triple-push the power door unlock button.
- Turn the key to “Off”.
- Push the power to unlock the button 3 times again.
People ask also, where is the reset button on a 2002 Ford Explorer?
Also know, how do I get my car out of anti theft mode? Step 1: Insert the key into the door lock. Use the side door on the driver’s side and the physical key even if there is a keyless entry system on the car. Step 2: Turn the vehicle key to unlock the car door without releasing it. Hold the key for 30 seconds in the position.Press the panic button one time. Now, go to the driver’s side of Your car, and get inside. Place Your physical key into the ignition key hole, and turn it to the on position three times in a 10 second period. Now, start the engine, and the anti-theft system should be reset.
How do I get my 2000 Ford Explorer out of theft mode?
Allow the driver’s door to be locked for at least 30 seconds, then use the key in the door cylinder to unlock it. This should clear anything that is wrong with the alarm system.
Why is my car in anti-theft mode?
An anti-theft system may also integrate a car alarm or it might just be an engine immobilizer. … This may be for many reasons including a dead car battery that loses its key memory or a dead battery in your remote. It could also be that your immobilizer chip is damaged in your key or the car door lock is damaged.
How do I reset my anti theft system?
Exit the car with all doors closed and the windows rolled up. Also close and any rear doors such as the trunk, rear hatch and front hood. Lock the car using the drivers side lock and walk away from the car at least ten feet. Wait for fifteen minutes and unlock the door, this should reset the security system.
How do I get my Mustang out of theft mode?
To reset the anti-theft on the vehicle You will need to first get into the vehicle and shut the doors. With the doors shut You want to put the key into the ignition slot and turn it on. Once You have turned it on You will then want to turn it back to the off position.
How do you reset the service engine soon light on a 2002 Ford Explorer?
Explorer Addict Just unhook the negative terminal for a few minutes and it should reset. OBDII resets the light anyway once the problem is gone, so if you think you’ve fixed the problem and the light is still on its prob. still there. The code will be stored in the computer but the light should be gone.
In the event of an accident, the “Fuel Reset Button” will turn off the fuel pump and system.
How do I reset my Ford Explorer computer?
- Open the hood of the Ford. Loosen the lock nut located on the negative battery cable connector with a socket and ratchet.
- Wait for 20 minutes while the PCM bleeds off the electricity it stores for backup power. Once the power drains from the PCM, it resets.
Is my car in anti-theft mode?
If the security or anti-theft light is flashing when you attempt to start your car, and the engine does not crank or does not start, you have an anti-theft problem.
How do I reset my immobilizer?
To reset the immobilizer, hold down the panic button. Wait for ten minutes if you push the lock button two times.
How do I reset my Saturn anti-theft system?
To reset the system, get in the car and shut the door. Turn the key on to the “Run” position without cranking the engine. Leave the key there for exactly 10 minutes. Turn the key to the off position without removing it and back to “Run” for 10 more minutes.