Likewise, how do you reset the oil change light on a 2010 Ford Explorer?
- Press and hold the SELECT/RESET stem for more than two seconds. Oil life is set to 100% and OIL LIFE SET TO 100% is displayed.
- Once OIL LIFE SET TO 100% is displayed, release, press and hold the.
- After setting the oil life start value, press the SELECT/RESET stem.
Also know, how do you reset the oil change light on a Ford Explorer? Turn the ignition to the ON position. Do not start the engine. Press and release the “Select/Reset” stem button on the instrument panel to toggle the options until the “Hold Reset For Setup Menu” option appears. Press “Select/Reset” to toggle the options until the “Hold Reset if New Oil” option appears.
Also, how do you reset the oil change light on a 2009 Ford Explorer?
People ask also, how do you reset the change oil engine oil light on a Ford Explorer 2011?
- Switch the ignition over to the on position.
- Go to the SETTINGS menu.
- Scroll and select VEHICLE.
- Scroll down to OIL LIFE RESET.
- Press and hold the OK button.
- Shut the vehicle off and then start it back up and check the oil change light should be gone.
If You see the wrench light turn on in the dash of Your 2010 Ford Explorer this means that Your ECU has detected a fault. I recommend getting off the road as soon as possible because continuing to drive can cause more damage to Your SUV.
Contents
How do you reset the oil life on a 2010 Ford Sport Trac?
- Turn the ignition to run (one position before starting engine).
- Press SETUP to display OIL LIFE %.
- Press RESET button to display “HOLD RESET IF NEW OIL”.
- Press and hold the RESET button for more than two seconds.
How do I reset my oil change light?
How do you reset the oil change light on a Ford app?
How do I reset my Ford Explorer?
- Open the hood: release the primary latch by pulling the release lever under the steering wheel near the floor board.
- Disconnect the negative battery terminal.
- Wrap the negative clamp in a towel.
- Leave the negative battery cable off for a minimum of five minutes.
How do you reset the oil change light on a 2008 Ford Explorer?
Turn the ignition to the “RUN” position. Enter “SYSTEM CHECK” menu and “OIL % OIL LIFE OK” will be displayed. Press “RESET” button, “HOLD RESET IF NEW OIL” will be displayed. Press and hold the “RESET” button for more than 2 seconds.
How much oil does a 2011 Explorer take?
Capacity: 6 quarts (with filter)After refill check oil level.
How do you reset the oil light on a 2015 Ford Explorer?
How do you reset the oil light on a Ford Ecosport?
Turn the ignition on without turning on the engine. Press both the break and gas pedals at the same time. After a few seconds the screen should say “service: oil reset in prog.” Keep pressing down on the break and gas for about 25 seconds until the screen says “service: oil reset complete”.
Is it safe to drive with wrench light on?
It is not safe to drive. The wrench light indicates something is wrong with your power train. When this light comes on, it means that your oil levels are low. You want to get that checked out fairly soon because ignoring it could damage your vehicle a lot.
Can you drive with wrench light on?
It is suggested that you have your car towed into a mechanic’s garage, or, if you are one of the lucky few who still have your car on and able to drive, you drive your vehicle to a garage immediately. It is unsafe to drive with this light on for long as it may stall and won’t come back on at any given moment.