Motorcraft® MERCON® LV is a premium-quality automatic transmission fluid recommended by Ford Motor Company for use in Ford, Lincoln and Mercury vehicles that require MERCON® LV type fluid.
Contents
How much transmission fluid does a 2012 Ford Fusion SE take?
The 2012 Ford Fusion’S3. 5 liter 6-cylinder engine is equipped with A6-speed automatic transmission that uses 9 quarts of Dexron ViATF fluid. A transmission flush and filter change is needed every 30,000-50,000 miles.
How many quarts does a 2012 Ford Fusion take?
2012 Ford Fusion – SpecsEngine3.0-liter V6 FFV2.5-liter I-4Fuel capacity16.5 gallons (AWD)17.5 gallons17.5 gallons (FWD)Fuel Requirement87 octane unleaded87 octane unleaded or E85 capableOil Capacity5.5 quarts with filter5.0 quarts with filter13 autres lignes
How much transmission fluid does a Ford Fusion take?
The Ford Fusion transmission fluid capacity iS5. 7 quarts. The transmission fluid needs to be replaced every 30,000 to 60,000 miles.
What are the symptoms of low transmission fluid?
1. Noises. If your transmission is working properly, you shouldn’t hear any noise while you’re driving as it should transition smoothly.
2. Burning Smell. Any foul smell coming from your car should direct you to your nearest service center.
3. Transmission Leaks.
4. Slipping Gears.
Do Ford Fusions have transmission problems?
FUSION: Owners of Ford Fusions have also reported issues that can be traced back to a defective transmission. These include rough gear shifting and shaking of the entire car, often when shifting into first gear. The Fusion has become an extremely popular car, and we hear continuous complaints about its performance.
Will a transmission flush hurt my car?
Almost every car manufacturer recommends against using transmission flushing chemicals, and most will void your transmission warranty if they can prove these chemicals are being used. These chemicals can damage your transmission, which is why most automakers recommend against them.
How often should you change transmission fluid Ford Fusion?
Every 150,000 miles: Change automatic transmission fluid, replace accessory drive belt, and replace timing belt.
How much does a slipping transmission cost?
How Much Does Transmission Repair Cost? Average transmission repairs can cost about $900 with prices that range from $300 to $1,500 dependent on what type of repair that is required to be completed. For instance, new transmission clutches will cost around $1,150 with average costs that range from $800 to $1,500.13 juil. 2020
How do you check the transmission fluid on a 2012 Ford Fusion?
Open the hood (with the engine running). Locate the transmission dipstick, pull it out and wipe it off. Reinsert the dipstick and pull it back out. Make sure that the fluid is within the hot operating temperature range.15 déc. 2015
What kind of engine does a 2012 Ford Fusion have?
The available engines are a 2.5-liter 175-hp I-4, a 3.0-liter 240-hp V-6, a 3.5-liter 263-hp V-6, and the 191-hp hybrid 2.5-liter I-4 drivetrain. Ford Fusion 0-60 mph times range from 8.9 seconds for the front-drive I-4-equipped Fusion SEL, to 6.8 seconds for both the front and all-wheel-drive Fusion Sport.
What size is the oil drain plug on a 2012 Ford Fusion?
14mm
What happens if you put too much transmission fluid in your car?
If you add too much transmission fluid, you will notice that it may foam, and that can bring about erratic gear shifting. Some other problems that may arise include oil starvation and transmission damage. … Adding too much transmission fluid can also cause early failure and damage of parts as result of excess pressure.
Can I add new transmission fluid to old?
You can just add new fluid without draining some, unless you are replacing what has leaked out. The transmission doesn’t have a plug like the oil pan either, you have to loosen the bolts all the way around the pan and be prepared to replace the gasket when you get ready to close.
Why is there no transmission dipstick?
Automatic transmissions which use World Standard (WS) fluid are sealed and do not consume fluid. This eliminates the need for periodic fluid checking using a dipstick.