Also, how do you reset the SRS light on a 2002 Honda Odyssey? Switch the ignition ON, the SRS light will appear for six seconds then OFF for four seconds. When the light goes OFF, REMOVE the paperclip. When the light comes ON, put the paperclip back IN. Once more, when the light goes OFF, REMOVE the paperclip.
Likewise, how do I get the SRS light off?
- Put the key into the ignition and turn the switch to the “on” position.
- Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
- Repeat Steps 1 and 2 two more times.
Furthermore, what does SRS mean on a 2002 Honda Odyssey? The SRS light referes to the supplemental restraint system. This involves your airbags. The light indicates that the system has a problem and is disabled. We need to get the vehicle in to do some testing to isolate the problem and figure corrective measures.
People also ask, how do you turn off the SRS light on a 2002 Honda Accord?
What is typical cost to resolve an illuminated Supplemental Restraint System (SRS) Warning Light? Expect to pay between $100 to $200 for the initial diagnostic.Contents
What would cause the SRS light to come on?
If the SRS light stays on or starts flashing on and off, you may have a problem with the airbags themselves, a loose wire, a faulty seat belt buckle, or a problem with the Engine Control Unit (ECU) that is causing the airbag warning light to stay on.
Will disconnecting the battery reset the airbag light?
Often, all it takes to get rid of that pesky warning light is to reset your airbag sensor. … Remove the terminal clamp and leave it disconnected for 5-10 seconds to allow the airbag sensor to reset. Then reconnect the battery terminal and turn the vehicle on. With a bit of luck, the light will stay off.
How do you reset the SRS airbag light?
How do I fix my SRS light on my Mitsubishi?
- Plug the Mitsubishi airbag scanner into the OBD2 port under the dashboard, driver’s side.
- Turn on the ignition and allow the scanner to power on.
- Select your Mitsubishi model and year.
- Select SRS / Airbag Control unit from the main menu.
- Select Read Fault Codes.
What does SRS light mean in Honda Odyssey?
Dear karinapr6– SRS stands for supplemental restraint system (airbags). Have your car hooked up to a diagnostic computer at a dealer or good repair shop. They will tell you if your problem is with the warning system or the restraint system itself. Do not ignore this warning.
What does red SRS light mean?
If the SRS light illuminates while you are driving, it signals there’s an issue with the car’s airbag system. It also means that the airbags may not deploy if you’re in an accident. If the light comes on, take your car to get the SRS sensor checked as soon as possible.
How do you reset the SRS light on a Honda?
- There is a yellow plug under the dash plugged into the fuse panel.
- Turn the ignition key to the “ON” (II) position.
- When the SRS light comes back on plug the jumper wire back in within 4 seconds the light will blink twice and go out.
- Unplug the jumper and turn the ignition key off.
How do you bypass the SRS light on a Honda?
What does the SRS light mean on a Honda Accord 2002?
The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system. The first thing I would check is the fuse for the SRS unit. The only way to check this is with a scan tool of some sort.
Where is the fuse for SRS light?
The fuse block is on the driver’s side of the engine compartment. Pull out the SRS fuse. In most models, this is fuse #40, located in the lower right corner of the fuse block.