Contents
How do you change a brake light on a Hyundai Elantra?
- Open trunk.
- Remove the cover and access the back of the tail light assembly.
- Disconnect the electrical wire.
- Remove the brake light socket by turning it counterclockwise.
- Remove the brake light bulb from the socket by pulling it out.
- Install the new brake light bulb into the socket.
Can I change my tail light myself?
Changing your tail light bulbs is an easy form of maintenance that you can perform on your vehicle. … You’ll see the wires connected to the back of the bulbs. If you’re changing a bulb in a vehicle that does not require you to remove the assembly, this is what you’ll see, only from inside the trunk or hatch.
How do you remove the tail light on a 2013 Hyundai Elantra?
How do you remove the tail light on a 2018 Hyundai Elantra?
How do you change a turn signal bulb on a 2017 Hyundai Elantra?
How do you change a tail light on a Hyundai?
- Open the trunk.
- Remove the three retaining bolts that hold the rear light assembly.
- Locate the socket for the defective bulb.
- Push the defective bulb into the socket and turn it counterclockwise until it releases.
What does the brake light mean on Hyundai Elantra?
Bad Switch: One common reason for the Parking Brake light to stay on is a failing or failed switch. This can be checked easily by jiggling the handle after it is down. If the light turns off (or turns off and then back on), the switch is the most likely culprit and will need to be replaced.
How do you change a brake light on a 2013 Hyundai Elantra?
How do you take off a tail light cover?
How much is it to replace a tail light?
A new tail light switch, accounting for labor, will cost from $70 to $100. The plastic and colored lens over on top is a bit more pricey. Depending on the make and model of your car, a replacement tail light lens will leave you lighter by between $100, and upwards of $750.
How do you tell if a tail light bulb is burnt out?
As noted above, once per week, take a few minutes during your day or evening to check if all brake lights are working. If the parking lights work (meaning the rear lights that turn on when the headlights are active), but when pressing the brake light the light does not work, have the tail lamp bulb replaced.