Open the hood of your Jeep Grand Cherokee. Lift the headlamp covers to expose the alignment screws on the headlamp. Use the Phillips screwdriver, Torx tool head, or Allen wrench to rotate the alignment screws. You should adjust the headlight beam to be approximately three feet above the ground.
Subsequently, how do you adjust the headlights on a Jeep Grand Cherokee? Locate the screw near the optic and adjust by screwing from right to left to adjust the height. The goal is for the light beams of your jeep grand cherokee to be just below the mark to sufficiently illuminate the roadway without dazzling.
Furthermore, how do you adjust headlights on a 2014?
Frequent question, where are the headlight adjustment screws? Most adjustment screws are located on the top and side of the light housing. They should be clearly marked. If you cannot locate the screws, check your owner’s manual. It should be noted that some manufacturers have located the adjustment screws in the engine compartment behind the headlight housing.
Amazingly, how do I adjust my headlights to aim?
Contents
How do you adjust left and right headlights?
One screw will adjust the headlight up/down while the other will adjust left/right – keeping your eye on the beam on the wall slowly turn one of the screws to determine which direction it’s adjusting, if it’s not the way you want turn it back to the original location and use the other screw.
What is the proper height for headlights?
The top of the low beam shining on the wall should be at or slightly below the height of the center of the headlight lens for most vehicles. You should expect the light pattern to be higher on the right side (passenger side) to illuminate road signs and lower on the driver’s side to prevent blinding other drivers.
Do you need to adjust headlights after leveling kit?
How to adjust your lifted truck’s headlights. In order to meet Department of Transportation requirements, you need to adjust each headlight top and bottom as well as each side.
How do you adjust Chevy headlights?
How do you remove headlight adjustment screws?
Remove the bolts above the headlight with a socket wrench After locating your adjustment screws, the next thing you want to do is remove the bolts. The bolts are on the car’s frame, right above the grill. Using your socket wrench, secure the bolts and rotate anti-clockwise till the bolts come off.
How far should your headlights shine while on low beam?
Q: How Far Should Your Headlights Shine While on Low Beam? A: According to the National Highway Traffic Safety Administration (NHTSA), the distance illuminated by low beam headlights is about 160 feet.
How do I fix my headlight adjuster screws?
How do you align high beams?
Using the alignment mechanisms in your vehicle, adjust one headlight vertically until the Alignment Point is even with the X axis. 8. On the same headlight, adjust horizontally until the Alignment Point is even with the Y axis.