- Turn the ignition switch to the ON position, do not start the engine.
- Fully depress the accelerator pedal slowly three times within 10 seconds.
- Turn the ignition switch to the OFF/LOCK position.
Also know, how do you reset the oil change message on a Jeep?
Likewise, how do I turn off my oil change notification?
- Press and hold the reset button.
- Turn the ignition back to the ON position while holding the reset button.
- Watch the oil change or maintenance light carefully.
- Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.
Also, how do you reset the oil change light on a 2012 Jeep Grand Cherokee?
People ask also, how do you reset the oil change light on a 2013 Jeep Grand Cherokee?
Does Jeep Use Synthetic Oil From The Factory? This is regular oil and the exact same oil found in your engine when you purchased it from the dealership. If you were to have your Jeep serviced at the dealership they would use this oil. The factory service manual recommends an oil change every 3000 miles.Contents
Will my jeep tell me when I need an oil change?
The indicator system will light up when an oil change is needed. Typical operating conditions means the car can last up to about 10,000 miles before needing the oil changed, but that may need to be adjusted depending on how the car is driven.
How do I reset my dashboard after oil change?
Insert the key into the ignition and turn it to the “on” position without starting the engine. Depress the gas pedal slowly three successive times within 10 seconds. At this point, the system should have reset. You can verify by turning the ignition off and then on again.
How do you reset mileage after oil change?
Why is my oil life low after oil change?
If your oil light stays on even after changing your engine oil, you’re going to want to check the sensor first to rule out a malfunctioning sensor as the cause. Dirt and other particles can make their way into the oil pump, causing the sensor to falsely identify oil issues. … The next common cause is low oil pressure.
How do you reset the oil life on a 15 Jeep Grand Cherokee?
How do you reset the perform service on a Jeep Grand Cherokee?
Locate the “Step” button on the Grand Cherokee’s instrument panel and press it. Press it again until it says “Miles to Service.” Press in and hold the button for about five seconds. It should read “Reset.” This will turn off the service light on the display.
How do you reset the computer on a Jeep Grand Cherokee?
- Disconnect the battery by removing the positive battery cable.
- Ground the positive cable to the negative cable for 30 seconds to erase the electric charge in the capacitors.
- Reconnect the positive cable to the battery.
- Turn the key to on but do not start.
- Turn the headlights on.
How do you reset the oil life on a 2017 Jeep Grand Cherokee?
Does Jeep Cherokee require synthetic oil?
Every Jeep Cherokee oil change is performed by our factory-trained mechanics and includes a multi-point inspection, as well. … For example, 4 cylinder passenger cars take less oil, and typically use conventional oil, compared to a vehicle with a high-performance V-8 engine, which may require full synthetic motor oil.
What brand oil Do Jeep dealers use?
Pennzoil® is the only motor oil recommended by the Jeep® brand in North America.