How to factory reset 2011 jeep grand cherokee?

In order to do this You will need to press and hold both the temperature up and temperature down buttons on the driver side of the controls. Do not let go until the display changes to the engineering menu. Scroll down in the menu until You see Reset to factory default and press it.

Best answer for this question, how do I reset my 2011 Jeep Grand Cherokee?

You asked, how do I reset my Jeep Grand Cherokee?

1. Turn the ignition switch to the “ON” position without starting the vehicle.
2. Press the gas pedal to the floor slowly three times within 10 seconds.
3. Turn the ignition off. Wait 10 seconds and start the engine.

Additionally, where is the TPMS reset button on a 2011 Jeep Grand Cherokee? To reset the tpms on the 2011 jeep grand cherokee make sure the tire pressure is correct, then turn on the vehicle. Now hit the reset button that is to the right of the steering wheel and wait ten minutes. In some cases you may need to hold the button down till the light flashes.

Quick Answer, how do you reset a PCM on a Jeep?

1. Disconnect the POSITIVE battery Terminal and touch it to ground for 30 seconds to discharge the PCM capacitors, which maintain the Adaptive Memory.
2. Reconnect the Battery Cable.
3. Turn Ignition Switch to the “On” position but DO NOT start the engine.
4. Turn Headlight On.
5. Turn Headlights Off.
6. Turn Ignition Key Off.

How do you reset the service light on a 2012 Jeep Grand Cherokee?

Where is the TPMS reset button on a Jeep Grand Cherokee?

To reset the tire pressure monitor or tpms system in your 2018 jeep grand cherokee vehicle, turn the ignition key to the “on” position and depress the tpms button, usually located under the dash, until the tpms light blinks several times.

How do you clear the error code on a Jeep Grand Cherokee?

1. Pull the release lever to open the hood from inside the vehicle.
2. Open the hood and place the support rod into position to prop up the hood.
3. Remove the nut connecting the negative battery terminal to the battery, using an open end wrench.
4. Allow the computer to reset.

How do I reset my Jeep?

Where is the TPMS reset button?

The TPMS reset button is usually located beneath the steering wheel. If you are unable to find it, refer to your vehicle’s owner’s manual. Inflate all tires to 3 PSI over their recommended amount, then deflate them completely. Be sure to include the spare tire, as it may have a sensor as well.

Where is the TPMS reset button on a 2012 Jeep Grand Cherokee?

Start the car and let it run for 20 minutes to reset the sensor. You’ll usually find the tire pressure monitor reset button beneath the steering wheel.

Where is the TPMS reset button on a Jeep Grand Cherokee 2010?

Turn the key to the “On” position, but don’t start the car. Locate the TPMS reset button under the steering wheel and press in, holding until the tire pressure light blinks three times.

How do I reset my Jeep ECM?

1. Disconnect the battery by removing the positive battery cable.
2. Ground the positive cable to the negative cable for 30 seconds to erase the electric charge in the capacitors.
3. Reconnect the positive cable to the battery.
4. Turn the key to on but do not start.
5. Turn the headlights on.

How do you reset the PCM?

1. Open the hood of the vehicle.
2. Disconnect the negative battery cable from the battery. Use a wrench to loosen the lock nut, and pull the cable off. This cuts the power to the PCM. Wait for five minutes.

How many miles does it take to reset a jeep computer?

For good measure. Anytime that you reset your Jeep PCM you should keep in mind that you will need to drive your car for approximately 10-15 miles so your Jeep ECM can re-learn your driving habits and fuel management.