Disconnect the battery by removing the positive battery cable. Ground the positive cable to the negative cable for 30 seconds to erase the electric charge in the capacitors. Reconnect the positive cable to the battery. Turn the key to on but do not start.
In this regard, how do I reset my jeep battery? Ground the positive battery cable to the negative battery terminal for about 30 seconds. Alternatively, you could also first disconnect the negative cable and move it well out of the way, then disconnect the positive cable and ground it to the metal frame for about 30 seconds as well. Either method should work.
Frequent question, how do I reset my Jeep Grand Cherokee?
- Turn the ignition switch to the “ON” position without starting the vehicle.
- Press the gas pedal to the floor slowly three times within 10 seconds.
- Turn the ignition off. Wait 10 seconds and start the engine.
Also the question is, how do you reset the computer on a 2018 Jeep Grand Cherokee? To do a soft reboot of Your touch screen in Your 2018 Jeep Grand Cherokee You’ll need to hold down the enter and volume buttons for 15 to 25 seconds. After this time has passed the screen will flash and then it should come back on and work like normal.
Quick Answer, how do I reset my 2005 Jeep Grand Cherokee?
- Turn the ignition switch to the “ON” position without starting the vehicle.
- Press the gas pedal to the floor slowly three times within 10 seconds. Turn the ignition off. Wait 10 seconds and start the engine.
Contents
How many miles does it take to reset a jeep computer?
For good measure. Anytime that you reset your Jeep PCM you should keep in mind that you will need to drive your car for approximately 10-15 miles so your Jeep ECM can re-learn your driving habits and fuel management.
To reset the tire pressure monitor or tpms system in your 2018 jeep grand cherokee vehicle, turn the ignition key to the “on” position and depress the tpms button, usually located under the dash, until the tpms light blinks several times.
What would cause a Jeep Cherokee to not start?
While there are a variety of reasons your Jeep Cherokee won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter.
How do I reset my oil change light on my Jeep Grand Cherokee?
- Turn the ignition switch to the ON position, do not start the engine.
- Fully depress the accelerator pedal slowly three times within 10 seconds.
- Turn the ignition switch to the OFF/LOCK position.
How do you reset the computer on a 2001 Jeep Grand Cherokee?
Put your key in the ignition and turn it to the “ON” position. Do not start the engine. Turn on the headlights, and leave them on for 10 to 20 seconds. Then turn off the headlights.
How do I reset my UConnect 8.4 jeep?
How do I reset my Jeep UConnect?
- Put your vehicle in park and ensure that it is in “RUn” mode.
- Press and hold both the volume and turner knob buttons simultaneously.
- Hold down the knobs for roughly 10-20 seconds.
- A screen should flash with your vehicle’s brand name, then go dark once more.
How do you clear the error code on a Jeep Grand Cherokee?
- Pull the release lever to open the hood from inside the vehicle.
- Open the hood and place the support rod into position to prop up the hood.
- Remove the nut connecting the negative battery terminal to the battery, using an open end wrench.
- Allow the computer to reset.
How do you reset the codes on a 2014 Jeep Grand Cherokee?
To turn off the Jeep Grand Cherokee check engine light, turn the ignition switch to ON but don’t start the vehicle. Press the gas pedal 3 times within 10 seconds and turn the ignition off. Wait 10 seconds and start the engine.