Also, how do you reset the oil life on a 2014 Jeep Cherokee? To reset the oil light to the 2014 jeep cherokee, you will turn the ignition to the on / run mode. Move the gas pedal slowly three times in 10 seconds. Change the ignition switch to the lock button. Repeat this process if the indicator appears again after the engine is started.
Also the question is, how do you reset the service light on a Jeep Cherokee?
- Turn the ignition switch to the “ON” position without starting the vehicle.
- Press the gas pedal to the floor slowly three times within 10 seconds.
- Turn the ignition off. Wait 10 seconds and start the engine.
Correspondingly, how do you reset the oil life on a Jeep Grand Cherokee?
- Turn the ignition switch to the ON position, do not start the engine.
- Fully depress the accelerator pedal slowly three times within 10 seconds.
- Turn the ignition switch to the OFF/LOCK position.
Considering this, how do you reset the codes on a 2014 Jeep Grand Cherokee? To turn off the Jeep Grand Cherokee check engine light, turn the ignition switch to ON but don’t start the vehicle. Press the gas pedal 3 times within 10 seconds and turn the ignition off. Wait 10 seconds and start the engine.Without starting the engine, turn the ignition in the ON/RUN mode position. In the instrument cluster display, navigate to “Vehicle Info” then “Oil Life.” Push and hold the ‘OK’ button until the oil life gauge resets to 100%.
Contents
How often should I change the oil in my 2014 Jeep Grand Cherokee?
Synthetic oil usually should be changed every 7,500 – 10,000 miles. An oil change is one of the most necessary and necessary services for your car. Jeep recommends getting your 2014 Jeep Grand Cherokee oil & filter changed each 3,000-5,000 miles for conventional oil.
What would cause a Jeep Cherokee to not start?
While there are a variety of reasons your Jeep Cherokee won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter.
How do I reset my Jeep?
To reset the tpms on the 2011 jeep grand cherokee make sure the tire pressure is correct, then turn on the vehicle. Now hit the reset button that is to the right of the steering wheel and wait ten minutes. In some cases you may need to hold the button down till the light flashes.
How do you reset the oil life on a 2010 Jeep Grand Cherokee?
How do I reset my oil life?
Hold the Reset Button and Turn the Key Turn the ignition back to the ON position while holding the reset button. Watch the oil change or maintenance light carefully. It should start to blink. Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.
How do you reset the oil life on a 2011 Jeep Grand Cherokee?
How do you reset the check engine light on a 2014 Jeep?
- Make sure the engine is not running and key is out of the ignition.
- Disconnect the battery terminals.
- Wait 5 minutes.
- Reconnect battery terminals.
- Insert and turn the ignition key to the run position without starting.
- All error codes are cleared and CHECK ENGINE icon disappeared.
Why is my check engine light on in my 2014 Jeep Grand Cherokee?
2014 Jeep Grand Cherokee Check Engine Light Flashing Different easy reasons for a Check Engine Light are dirty mass airflow sensor, damaged oxygen sensor, faulty head gasket, faulty emissions control part, a malfunction with the fuel injection system, or defective spark plugs to name several.
How do you reset the gas cap on a Jeep Grand Cherokee?
To reset the gas cap light in your Jeep Grand Cherokee, turn the vehicle off and replace or tighten your gas cap and then reset the warning light using an OBD-II scanner plugged into the port beneath your steering column.