To reset the oil light to the 2014 jeep cherokee, you will turn the ignition to the on / run mode. Move the gas pedal slowly three times in 10 seconds. Change the ignition switch to the lock button. Repeat this process if the indicator appears again after the engine is started.
Also the question is, how do you reset the oil life on a Jeep Cherokee?
- Shift the gear to the “Park/P” position.
- Without holding the brake pedal, press the Start/Stop button to turn on the electronics.
- On the steering wheel, navigate to the “Oil Life” selection under “Vehicle Info“.
- Push and hold the OK button until the oil light percentage changes to 100%.
Furthermore, how do you reset the codes on a 2014 Jeep Grand Cherokee? To turn off the Jeep Grand Cherokee check engine light, turn the ignition switch to ON but don’t start the vehicle. Press the gas pedal 3 times within 10 seconds and turn the ignition off. Wait 10 seconds and start the engine.
Additionally, how do you reset the oil light on a 2014?
You asked, how do you reset the oil life on a 2015 Jeep Cherokee?
Contents
What kind of oil does a Jeep Cherokee 2014 take?
The 2014 Jeep Cherokee uses SAE 5W-20 motor oil in the engine. Jeep recommends that You use synthetic oil whenever You need to replace it.
How do you reset the check engine light on a 2014 Jeep?
- Make sure the engine is not running and key is out of the ignition.
- Disconnect the battery terminals.
- Wait 5 minutes.
- Reconnect battery terminals.
- Insert and turn the ignition key to the run position without starting.
- All error codes are cleared and CHECK ENGINE icon disappeared.
How do I reset the code on my Jeep Grand Cherokee?
- Pull the release lever to open the hood from inside the vehicle.
- Open the hood and place the support rod into position to prop up the hood.
- Remove the nut connecting the negative battery terminal to the battery, using an open end wrench.
- Allow the computer to reset.
How do you reset the gas cap on a Jeep Grand Cherokee?
To reset the gas cap light in your Jeep Grand Cherokee, turn the vehicle off and replace or tighten your gas cap and then reset the warning light using an OBD-II scanner plugged into the port beneath your steering column.
How do you reset the oil light on a 2014 Jeep Grand Cherokee?
How do you reset the maintenance light on a 2014 Jeep Wrangler?
How many quarts does a 2014 Jeep Cherokee take?
Capacity: 5.5 quarts (with filter)After refill check oil level.
How do you reset the oil life on a 16 Jeep Cherokee?
How much oil does a 2015 Jeep Cherokee take?
Capacity: 5.5 quarts (with filter)After refill check oil level.