- Turn the ignition switch to the “ON” position without starting the vehicle.
- Press the gas pedal to the floor slowly three times within 10 seconds.
- Turn the ignition off. Wait 10 seconds and start the engine.
Moreover, how do you reset the perform service light on a 2004 Jeep Grand Cherokee?
Similarly, how do you reset the perform service on a 2005 Jeep Grand Cherokee?
Likewise, how do you reset the perform service on a 2006 Jeep Grand Cherokee? Locate the “Step” button on the Grand Cherokee’s instrument panel and press it. Press it again until it says “Miles to Service.” Press in and hold the button for about five seconds. It should read “Reset.” This will turn off the service light on the display.
Subsequently, how do I get rid of Jeep perform service?
- Turn on the engine.
- On the vehicle’s dash, press the “Step” button until “Miles to Service” is displayed.
- Press and hold the “Reset” button, near the “Step” button, until the “Miles to Service” flashes and resets. Verify the “Perform Service” light goes away.
- Pull the release lever to open the hood from inside the vehicle.
- Open the hood and place the support rod into position to prop up the hood.
- Remove the nut connecting the negative battery terminal to the battery, using an open end wrench.
- Allow the computer to reset.
Contents
How do you reset the check engine light on a 2018 Jeep Grand Cherokee?
To turn off the Jeep Grand Cherokee check engine light, turn the ignition switch to ON but don’t start the vehicle. Press the gas pedal 3 times within 10 seconds and turn the ignition off. Wait 10 seconds and start the engine.
To reset the tire pressure monitor or tpms system in your 2018 jeep grand cherokee vehicle, turn the ignition key to the “on” position and depress the tpms button, usually located under the dash, until the tpms light blinks several times.
How do I reset my Jeep?
What does perform service mean on Jeep Grand Cherokee?
When the “Perform Service” indicator comes on, this lets you know your Jeep has reached its scheduled mileage for needing regular maintenance. This means you need to take it to a professional to have specific fluids swapped, tires rotated, or something similar.
How do you reset a Jeep Grand Cherokee computer?
- Disconnect the battery by removing the positive battery cable.
- Ground the positive cable to the negative cable for 30 seconds to erase the electric charge in the capacitors.
- Reconnect the positive cable to the battery.
- Turn the key to on but do not start.
- Turn the headlights on.
Depress the TPMS button located under the steering wheel until it flashes three times. Start the engine and idle for 20 minutes while the system records and stores the PSI of each wheel. Alternatively, You may disconnect the positive battery cable for 15 minutes and reconnect.
How do you reset the service light on a 2008 Jeep Grand Cherokee?
How do I reset my performance service?
What would cause a Jeep Cherokee to not start?
While there are a variety of reasons your Jeep Cherokee won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter.
What does the check engine light mean on a Jeep Grand Cherokee?
If the check engine light in your 2020 Jeep Grand Cherokee starts flashing, that means that the problem needs immediate attention and your Jeep should be transported in shortly. This blinking light usually indicates a severe engine misfire allowing unburned fuel to be dumped into the exhaust system.