How to reset service light on jeep cherokee?

1. Turn the ignition switch to the “ON” position without starting the vehicle.
2. Press the gas pedal to the floor slowly three times within 10 seconds.
3. Turn the ignition off. Wait 10 seconds and start the engine.

Furthermore, how do you reset the oil life on a Jeep Cherokee?

1. Shift the gear to the “Park/P” position.
2. Without holding the brake pedal, press the Start/Stop button to turn on the electronics.
3. On the steering wheel, navigate to the “Oil Life” selection under “Vehicle Info“.
4. Push and hold the OK button until the oil light percentage changes to 100%.

Similarly, how do you reset the oil life on a 2017 Jeep Cherokee?

Beside above, how do you reset the maintenance light on a 2016 Jeep Cherokee?

Likewise, how do you reset the maintenance light on a 2012 Jeep Grand Cherokee?

How do you reset the oil life on a 2011 Jeep Cherokee?

How do you reset the service light on a Jeep?

1. Turn the ignition switch to the “ON” position without starting the vehicle.
2. Press the gas pedal to the floor slowly three times within 10 seconds.
3. Turn the ignition off. Wait 10 seconds and start the engine.

How do you reset the oil change light on a 2018 Jeep Cherokee?

How do you reset the oil light on a 2015 Jeep Cherokee?

1. Turn the ignition to run (one position before starting engine).
2. Fully depress the accelerator pedal slowly three times within 10 seconds.
3. Turn the ignition off and then start the engine to verify the indicator has been reset.

How do you reset the tire pressure light on a 2011 Jeep Grand Cherokee?

If You are looking to simply reset the TPS on the 2011 Jeep Cherokee locate the TPMS reset button under the steering wheel and press in, holding until the tire pressure light blinks three times. Start the car and wait 20 minutes for the sensor to refresh.

How do you reset the oil change light on a 2010 Jeep Grand Cherokee?

How do you reset the oil change light on a 2020 Jeep Grand Cherokee?

Why is my change oil light still on?

If your oil light stays on even after changing your engine oil, you’re going to want to check the sensor first to rule out a malfunctioning sensor as the cause. Dirt and other particles can make their way into the oil pump, causing the sensor to falsely identify oil issues. … The next common cause is low oil pressure.

How do you reset the dashboard warning light?

1. Open the hood of your vehicle.
2. Loosen the nut that holds the negative terminal to the battery with the pliers.
3. Completely remove the cable from the negative battery terminal.
4. Leave the battery disconnected for 10 minutes to ensure that the computer is fully reset.

Can you still drive with oil light on?

You should not drive with the Oil Light on as this can cause extensive damage to your vehicle’s engine. … If this light comes on, pull over to the side of the road and turn the vehicle off so as not to do any further damage, and seek to have your Oil Light inspected as soon as possible.