Question : how to program ignition switch jeep grand cherokee?

1. Insert first programmed key into ignition and turn ignition switch to ON for 5 seconds.
2. Turn ignition switch to OFF and remove key.
3. Insert second programmed key into ignition and turn ignition switch to ON.
4. Turn ignition switch to OFF and remove key.

Furthermore, how do I program my Jeep key ignition?

Also, how do I reprogram my ignition key?

1. Insert the key into the ignition, and turn it to the on position.
2. Leave the key in this position for 10 minutes and 30 seconds, and then turn it off.
3. Turn the key back on, and wait for additional 10 minutes and 30 seconds before turning it off again.
4. Repeat the process for a third time.

Moreover, how do you program the ignition key on a 2004 Jeep Grand Cherokee?

1. Press and release the “lock” button in two-second intervals.
2. Turn the ignition on.
3. Press and hold the “unlock” button for up to 10 seconds.
4. Hold the “unlock” button, while pressing the “panic” button.
5. Complete the process by programming a button into the system.

Similarly, how do I program my 2000 Jeep Cherokee Key?

Can you program a key fob yourself?

DIY Key Fob Programming Depending on the age and model of your car, you may be able to program a replacement yourself. The procedure for do-it-yourself key fob programming can vary: Some automakers provide instructions in their owner’s manuals. Information can be found in many cases on the internet.

Does ignition switch need to be programmed?

Ignition switches can now be programmed to electronic ignition keys to add extra security and safety to your vehicle. These keys are synced with your engine to start your car, and once you program them, only a programmed key will start your car.

How can I program my car key without the original?

1. Insert original key and turn on.
2. Wait 5 seconds or until flashing security light goes off.
3. Within 10 seconds insert new key and turn on.
4. Wait 5 seconds or until flashing security light goes off.
5. Key is now programmed.

How do you program a car key with only one key?

How do I get the code for my Jeep Grand Cherokee?

1. Get behind the Grand Cherokee’s wheel and slide your key into the ignition. Turn the key in the following pattern: On-Off-On-Off-On.
2. Grab a pen and paper and count the number times the check engine light flashes at you. It will be a code.

How do I program my 2006 Jeep Grand Cherokee key?

1. Insert First Programmed Key. INSERT a working remote head key into the Ignition and TURN it to the ON/RUN position.
2. Remove First Programmed Key.
3. Insert Second Programmed Key.
4. Remove Second Programmed Key.
5. Program Remote.
6. Program Additional Remote.
7. Exit Programming Mode.
8. Test Remotes.

How do you bypass the immobilizer on a Jeep Grand Cherokee?

How do you reset the anti theft system on a 2001 Jeep Grand Cherokee?

Insert your key and turn the drivers side door lock to the right , then left and then right again this will reset the security system.

Why won’t my key turn in my Jeep Grand Cherokee?

What are common reasons my Jeep Grand Cherokee key won’t turn? While there are a variety of reasons your Jeep Grand Cherokee key won’t turn, the most common 3 are a binding steering column/lock, an ignition switch issue, or a problem with the ignition key.

How do I reprogram my Jeep Cherokee key fob?

With the door still open, move the switch on the door to the “LOCK” position. Turn the key to the “ON” position in the ignition. Press the “LOCK” button on your remote and hold for five seconds. Release the button and remove the key from the ignition to see if you successfully handled Jeep Key fob programming!