- Engage the parking brake on your vehicle.
- Start the Jeep and let it idle for about 15 minutes.
- Pop the hood and locate the dipstick near your car’s transmission.
- Remove the dipstick and wipe off any transmission fluid.
- Replace the dipstick.
As many you asked, how do I add transmission fluid to my 2015 Jeep Cherokee? Remove the fill plug from the right rear of the transmission case. Add transmission fluid until it trickles from the fill opening. Install the fill plug. Lower the vehicle for access to inside of the vehicle, leaving the tires at least 8 inches off the ground.
Subsequently, how do you check the transmission fluid on a 2015 Jeep Cherokee?
Furthermore, how do you check the transmission fluid in a Jeep Cherokee?
- First, turn on your car and warm up your engine.
- Next, find the transmission fluid dipstick, which, on FWD vehicles, is typically found next to your oil dipstick.
- Once you know where it is, simply remove the dipstick and touch the fluid.
Beside above, what kind of transmission fluid does a 2015 Jeep Cherokee take? Lubegard Synthetic Synthetic Transmission Fluid Dexron VI 1 Quart.Most new vehicles are equipped with an automatic transmission. As a result, there’s not really much maintenance to perform. Still, most owner’s manuals will recommend changing the transmission fluid every 90,000 miles or so.
Contents
Is there a recall on 2015 Jeep Cherokee?
Chrysler (FCA US LLC) is recalling certain model year 2015 Jeep Cherokee vehicles manufactured October 1, 2014, to June 18, 2015. The affected vehicles may have a misrouted air conditioning suction/discharge hose. Tip: Recalls don’t affect every vehicle of the same year, make and model.
Why is there no transmission dipstick?
Automatic transmissions which use World Standard (WS) fluid are sealed and do not consume fluid. This eliminates the need for periodic fluid checking using a dipstick. The transmission fluid does not need to be replaced unless an inspection shows it has become necessary.
How do you check transmission fluid in a Jeep?
- When you’re learning how to check transmission fluid, start by turning the car on.
- Begin looking for the transmission fluid dipstick.
- Once the dipstick has been located, remove it and touch a bit of fluid.
- Wipe the dipstick clean with a rag, and reinsert it back into the vehicle.
Where is the transmission dipstick?
Transmission dipsticks are usually on the passenger side of the engine bay in rear-wheel-drive vehicles and on the driver’s side in front-wheeled ones. If you can’t locate your car’s transmission dipstick, your owner’s manual will contain that information. Or you can check online for your specific car model.
How do you check transmission fluid without a dipstick?
What are the signs that your transmission is going out?
- Refusal to Switch Gears. If your vehicle refuses or struggles to change gears, you’re more than likely facing a problem with your transmission system.
- Burning Smell.
- Neutral Noises.
- Slipping Gears.
- Dragging Clutch.
- Leaking Fluid.
- Check Engine Light.
- Grinding or Shaking.
How do you change the transmission fluid on a Jeep Cherokee?
What type of transmission fluid does a Jeep Cherokee use?
Recommended fluid for the AW4 transmission is Jeep or Mopar Mercon automatic transmission fluid. Mopar Dexron II may also be used if Mercon is not available.
How much does it cost to change transmission fluid?
How Much Does a Transmission Fluid Change Cost? The cost to have your fluid changed by a dealer, service center or independent mechanic ranges from $80 to $250. The average cost is around $100 for both automatic and manual transmissions.
When should transmission fluid be changed?
If you drive manual, most manufacturers will recommend changing your transmission fluid every 30,000 to 60,000 miles. If you have automatic, you can typically boost that range up to 60,000 to 100,000 miles. There’s no harm in changing your fluid early.