- Shift the gear to the “Park/P” position.
- Without holding the brake pedal, press the Start/Stop button to turn on the electronics.
- On the steering wheel, navigate to the “Oil Life” selection under “Vehicle Info“.
- Push and hold the OK button until the oil light percentage changes to 100%.
Best answer for this question, how do you reset the oil life on a 2016 Jeep Cherokee?
You asked, how do you reset the oil life on a 2014 Jeep Cherokee? To reset the oil light to the 2014 jeep cherokee, you will turn the ignition to the on / run mode. Move the gas pedal slowly three times in 10 seconds. Change the ignition switch to the lock button. Repeat this process if the indicator appears again after the engine is started.
Correspondingly, how do you reset the oil life on a jeep? Without starting the engine, turn the ignition in the ON/RUN mode position. In the instrument cluster display, navigate to “Vehicle Info” then “Oil Life.” Push and hold the ‘OK’ button until the oil life gauge resets to 100%.
Additionally, how do you reset the service light on a Jeep?
- Turn the ignition switch to the “ON” position without starting the vehicle.
- Press the gas pedal to the floor slowly three times within 10 seconds.
- Turn the ignition off. Wait 10 seconds and start the engine.
- Turn the ignition to run (one position before starting engine).
- Fully depress the accelerator pedal slowly three times within 10 seconds.
- Turn the ignition off and then start the engine to verify the indicator has been reset.
Contents
How do you reset the oil life on a 2017 Jeep Grand Cherokee?
How do I reset my oil life?
Hold the Reset Button and Turn the Key Turn the ignition back to the ON position while holding the reset button. Watch the oil change or maintenance light carefully. It should start to blink. Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.
Why is my oil change light still on?
If your oil light stays on even after changing your engine oil, you’re going to want to check the sensor first to rule out a malfunctioning sensor as the cause. Dirt and other particles can make their way into the oil pump, causing the sensor to falsely identify oil issues. … The next common cause is low oil pressure.
Does Jeep use synthetic oil from the factory?
Does Jeep Use Synthetic Oil From The Factory? This is regular oil and the exact same oil found in your engine when you purchased it from the dealership. If you were to have your Jeep serviced at the dealership they would use this oil. The factory service manual recommends an oil change every 3000 miles.
How do I reset my Jeep?
To reset the tire pressure monitor or tpms system in your 2018 jeep grand cherokee vehicle, turn the ignition key to the “on” position and depress the tpms button, usually located under the dash, until the tpms light blinks several times.
How do I check the oil on my Jeep Cherokee?
How do you reset the oil light on a 2013 Jeep Cherokee?
How do you reset the computer on a Jeep Grand Cherokee?
- Disconnect the battery by removing the positive battery cable.
- Ground the positive cable to the negative cable for 30 seconds to erase the electric charge in the capacitors.
- Reconnect the positive cable to the battery.
- Turn the key to on but do not start.
- Turn the headlights on.
How do you reset percentage after oil change?
Step 1: Turn your Civic ignition on without starting your engine or press the start button twice without touching the brake. Step 2: Press the Trip knob repeatedly until the Engine Oil Life percentage displays. Step 3: Press and hold the trip knob until the Engine Oil Life percentage starts to blink.